Filter
Top Products
12
SPECIFICATIONS
Power Supply/ Miscellaneous
Power requirements .................... AC 220 - 230 V, 50/60 Hz
Power consumption .....................................................80 W
Dimensions (including knobs and other protruding parts)
......................................420 (W) X 114 (H) X 307 (D) mm
Weight (without package) ...........................................4.3 kg
Accessories
Operating Instructions........................................................ 1
Power cord (Rated current 2.5 A)....................................... 1
Warranty card..................................................................... 1
NOTE:
Specifications and design are subject to possible modification
without notice, due to improvements.
* Measured with DIRECT button set to on.
** Measured by Audio Spectrum Analyzer.
Amplifier Section
Continuous power output
(both channels driven at 20 Hz to 20 kHz)**
T.H.D. 0.1 %, 8 Ω .....................................30 W + 30 W*
DIN Continuous power output
(both channels driven at 1 kHz)
T.H.D. 1.0 %, 8 Ω .......................................40 W + 40 W
Total harmonic distortion**
20 Hz to 20 kHz, 15 W, 8 Ω................................ 0.08 %*
÷
The above values are applicable when AC 230 V power is
supplied.
Input sensitivity/ impedance
PHONO (MM)........................................... 2.8 mV/ 50 kΩ
CD, TUNER, LINE, TAPE1/CD-R/MD, TAPE2 MONITOR
................................................................. 200 mV/ 50 kΩ
PHONO (MM) overload level
1 kHz, T.H.D. 0.1 %............................................. 150 mV
Output level/ impedance
TAPE1 REC, TAPE2 MONITOR REC ......... 200 mV/ 1 kΩ
Frequency response
PHONO (MM)...........................20 Hz to 20 kHz ± 0.5 dB
CD, TUNER, LINE, TAPE1/CD-R/MD, TAPE2 MONITOR
.....................................................5 Hz to 100 kHz dB*
Tone control
BASS .......................................................± 8 dB (100 Hz)
TREBLE ................................................... ± 8 dB (10 kHz)
Loudness contour (volume control set at – 30 dB position)
......................................+ 6 dB (100 Hz)/ + 4 dB (10 kHz)
Signal-to-Noise ratio (IHF short circuit, A network)
PHONO (MM, 5 mV input) ................................... 85 dB*
CD, TUNER, LINE, TAPE1/CD-R/MD,TAPE2 MONITOR .
............................................................................ 106 dB*
Signal-to-Noise ratio (DIN, continuous power/ 50 mW)
PHONO (MM)............................................71 dB/ 67 dB*
CD, TUNER, LINE, TAPE1/CD-R/MD, TAPE2 MONITOR
...................................................................91 dB/ 71 dB*
Printed in <ARB7237-A>
Published by Pioneer Corporation.
Copyright © 2000 Pioneer Corporation.
All rights reserved.
<00B00ZF0P00>
+0
– 3
PIONEER CORPORATION
4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan
PIONEER ELECTRONICS [USA] INC.
P.O. BOX 1540, Long Beach, California 90801-1540, U.S.A.
PIONEER ELECTRONICS OF CANADA, INC.
300 Allstate Parkway, Markham, Ontario L3R OP2, Canada
PIONEER ELECTRONIC [EUROPE] N.V.
Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium TEL: 03/570.05.11
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
178-184 Boundary Road, Braeside, Victoria 3195, Australia, TEL: [03] 9586-6300
PIONEER ELECTRONICS DE MEXICO S.A. DE C.V.
San Lorenzo Num 1009 3er piso Desp. 302 Col. Del Valle, Mexico D.F. C.P. 03100 TEL: 5-688-52-90