Filter
Top Products
4 If the power light (A-1) does not flash, reposition the remote control
antenna at the rear of the additional receiver unit (B-28).
The power light on the transmitter unit should now flash when a remote
control command is given at the receiver side. If the VL1400 Wireless
TV link was working correctly before you installed the additional
VL1405 Receiver the video source should response.
5 If the video source does not respond to the remote command,
try realigning the front of the transmitter unit with the front of the
video source until you get a response.
6 If the video source still fails to respond install the remote control blaster
cord as described in the instructions for use of the VL1400 Wireless
TV link.
Using the wireless link with TV3
Watching and controlling video sources on TV3
1 Switch on TV3.This is the TV that is connected to the VL1405 receiver.
It is not necessary to switch on TV1 to enjoy video programmes on TV3.
2 Press the power button (B-19) to switch on the receiver unit.
When the receiver unit is switched on, the transmitter unit switches on
automatically and TV3 displays the signal on its SCART input.
3 Press the – or + buttons (B-22) on the receiver unit to select the
video source to be displayed.
The selection cycle is SCART input 1> 2 > 3 > 4
4 Aim the remote control at the receiver unit to control the video source.
ENGLISH 9
STANDBY
XP SBC VL1405 04-08-2003 14:39 Pagina 9