Filter
Top Products
English
5
Headphone (figure 2)
8 Power indication – lights up when in use.
9 Power On/Off – slide the switch to the
on or off position to switch the headphone
on/off.
10 Battery compartment – remove the
earcushion, take out the batteries and put
them in the transmitter’s recharging
compartment for recharging.
11 Volume – adjust volume to your desired
listening level.
12 Tuning – turn the tuning wheel until the
signal is at its clearest.
Transmitter power supply
IMPORTANT
Use only Philips SBC CS030/00
12 Volt/200 mA AC/DC adapter.
1 Make sure the adapter’s rated voltage
corresponds to the mains socket voltage.
2 Connect the DC connector of the AC/DC
adapter to the 12 Volt DC power input
connector located at the rear of the
transmitter.
3 Connect the 12 Volt/200 mA AC/DC
adapter to the mains socket.
– Always disconnect the AC/DC adapter if
the transmitter is not to be used for a
long period of time.
4 Insert the antenna tube in the hole, located
on the top of the transmitter.Ensure that
the wire which is hanging out of that hole, is
guided in the antenna tube.
– Installing the antenna tube correctly,will
improve the transmission range.
Headphone power supply
IMPORTANT
Use only rechargeable LR03/AAA NiCd
batteries (preferably Philips).
Do not use NiMH batteries or
alkaline batteries as these may damage
your FM wireless system!
1 Check if the power button of the
FM headphone is in the on position.
2 To recharge the headphone’s built-in
rechargeable LR03/AAA NiCd batteries,
open the headphone’s battery
compartment.Take out the batteries and
put them in the transmitter’s recharging
compartment for recharging.
Notes:
Completely flat batteries need approximately
16 hours to recharge.
Always remove the batteries if the
headphone is not to be used for a long period
of time.
Batteries contain chemical substances,
so they should be disposed of properly.
Controls Installation
Environmental Information
All redundant packing material has been omitted.We have done our best to make the
packaging easily separable into two materials:cardboard and polyethylene
Your unit consists of materials which can be recycled if disassembled by a specialized
company.Please observe the local regulations regarding the disposal of packing
materials,exhausted batteries and old equipment.
XP SBC HC 8349/00 nieuw 02-01-2002 11:23 Pagina 5