Filter
Top Products
English
4
To ensure you get the best performance
from your FM wireless stereo sound system
please read this manual carefully.
IMPORTANT
Read these instructions.All the safety
and operating instructions should be
read before using the wireless
headphone system.
Check if the voltage indicated on the
type plate of the adapter corresponds
to the local mains voltage before
connecting to the mains power supply.
Remove the batteries from the
headphone’s battery compartment and
disconnect the adapter from the mains
if the system is not in use for a long
period.
Prevent fire or shock hazard:do not
expose this equipment to humidity,
rain,sand or excessive heat caused by
heating equipment or direct sunlight.
Radio equipment for wireless audio
applications is not protected against
disturbance from other radio services.
IMPORTANT
Before using the FM headphone for the
first time, please ensure that the
batteries are fully charged for about
16 hours.This will guarantee a longer
operating lifetime of the batteries.
Multiple headphones with one
transmitter
An additional number of headphones
and/or wireless speakers can be used with a
single transmitter if they:
- operate in the 864 MHz band
- can detect a 19 kHz pilot tone.
Please consult the appliance’s electrical
specification sheets for confirmation on
compatibility.
Kit contents
This FM headphone system consists of the
following accessories:
1 x SBC HC8352 FM transmitter
1 x SBC HC8355 FM headphone
1 x SBC CS030/00 12Volt / 200mA AC/DC
adapter
2 x rechargeable batteries LR03/AAA
(NiCd), 220 mAh
1 x antenna tube
Transmitter (figure 1)
1 Recharging indicator – the green LED
lights up during recharging. Completely flat
batteries will be fully charged after about
16 hours.
2 Power indicator – lights up when audio
signals are detected at the audio input.
3 Recharging compartment – just place
the batteries in the transmitter’s battery
compartment.The green LED lights up
during recharging.
4 DC power – connect to the 12 Volt/
200 mA AC/DC adapter
5 3.5 mm stereo headphone audio
input – connects your FM transmitter to
an audio source
6 Channel switch – select one of
2 channels for best reception.We advise
you to select channel 1 as a first option.
7 Controls plate
General information Controls
XP SBC HC 8349/00 nieuw 02-01-2002 11:23 Pagina 4