29
English
3139 115 20411
2 Press CD, TUNER or TAPE to select the
desired source.
● Make sure the music source has been prepared.
CD – Load the disc(s). To start from a specific
track, make a program (refer to “CD Operation -
Programming the disc tracks”).
TUNER – tune to the desired preset radio
station.
TAPE – load the prerecorded tape into tape
deck 2.
3 Press à or á on the system repeatedly to set
the hour for the timer to start.
4 Press í or ë on the system repeatedly to set
the minute for the timer to start.
5 Press CLOCK/TIMER to store the start time.
➜ The timer is now set and activated.
➜ TIMER will remain on the display.
● At the preset time, the selected source will be
played.
To exit without storing the setting
● Press Çon the system.
Notes:
– If the selected source (CD or TAPE) is not
available when preset timer is reached, TUNER will
be selected automatically.
– During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
● Press TIMER ON/OFF on the remote control.
➜ The display will show "CANCEL" and TIMER
will disappear from the display.
To activate the TIMER
● Press TIMER ON/OFF on the remote control.
➜ The last timer setting will be shown for a few
seconds and TIMER will appear on the display.
Sleep Timer Setting
The sleep timer enables the system to switch to
Standby mode automatically at a preset time.
1 Set the clock (refer to “Clock Setting”).
2 Press SLEEP on the remote control repeatedly
to select a preset time.
➜ The selections are as follows (time in
minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF ™ 60 …
➜ "SLEEP XX" or "OFF" will be displayed. "XX"
is the time in minutes.
3 When you reach the desired length of time, stop
pressing the SLEEP button.
➜ The Sleep Timer is now set. After this
amount of time passes, the system will switch to
Standby mode.
To deactivate the Sleep Timer
● Press SLEEP repeatedly until "OFF" is displayed,
or press the STANDBY ON button.
Clock/Timer
pg 001-033/P900/37-Eng 12/8/00, 1:53 PM29