Filter
Top Products
10
English
3139 115 20411
Preparations
C Speakers Connection
Front Speakers
Connect to the SPEAKERS (FRONT) terminals,
right speaker to "R" and left speaker to "L".
Colored (marked) wire to "+" and black
(unmarked) wire to "-".
1
2
● Clip the stripped portion of the speaker wire as
shown.
Rear Surround Speakers
Connect to the REAR SURROUND terminals,
right speaker to "R" and left speaker to "L".
Colored (marked) wire to "+" and black
(unmarked) wire to "-".
Center Speaker
Connect to the CENTER terminal. Colored
(marked) wire to "+" and black (unmarked)
wire to "-".
Notes:
– For optimal sound performance, it is
recommended that the supplied speakers be used.
– Do not connect more than one speaker to any
one pair of
+
/
-
speaker terminals.
– Do not connect speakers with impedance lower
than the speakers supplied. Please refer to the
SPECIFICATIONS section of this manual.
D Subwoofer Out Connection
Connect the subwoofer to the SUBWOOFER
OUT terminal. The subwoofer reproduces just
the low bass sound effect (explosions or the
rumble of spaceships for example).
Optional Connections
The equipment and connecting cords are not
supplied. Refer to the operating instructions of
the connected equipment for details.
Line Out Connection
Connect this output to any analog audio
equipment for playback or recording (CD recorder,
tape recorder or amplifier for example). Use a
cinch cable to connect the LINE OUT terminals
to the analog audio inputs of the equipment.
Connecting other equipment to your
system
Connect the audio left and right OUT terminals
of a TV, VCR, Laser Disc player, DVD player or
CD Recorder to the AUX/CDR IN terminals.
Notes:
– Do not connect equipment to both LINE OUT
and AUX/CDR IN terminals simultaneously.
Otherwise, noise will be generated and malfunction
might occur.
– If you are connecting an equipment with mono
output, connect it to the AUX/CDR IN left terminal.
Alternatively, you can use a “single to double” cinch
cable.
Wireless Surround Out Connection
Connect the transmitter unit of wireless rear
speakers to the SURROUND OUT terminal.
Note:
– The availability of a wireless transmitter and its
peripherals are subjected to the approval of local
authorities. Please check with your respective local
safety or approving authority.
Digital Out Connection
Connect this digital output for recording on any
audio equipment with digital input (CD
Recorder, Digital Audio Tape [DAT] deck, Digital
to Analog Converter and Digital Signal Processor
for example). Use a cinch cable to connect the
DIGITAL OUT terminal to the digital input of
the equipment.
Inserting batteries into the
Remote Control
Insert two batteries
(Type R06 or AA) into
the remote control with
the correct polarity as
indicated by the + and
- symbols inside the
compartment.
CAUTION
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances, so
they should be disposed off properly.
pg 001-033/P900/37-Eng 12/8/00, 1:52 PM10