Filter
Top Products
26
English
RECORDING
Notes:
– For recording, use only tape of IEC type I
(normal tape) or IEC type II (Cr0
2
).
– The tape is secured at both ends with
leader tape. At the beginning and end of
tape, nothing will be recorded for six to
seven seconds.
– The recording level is set automatically,
regardless of the position of Volume,
DBB or DSC.
– To prevent accidental recording, break
out the tab on the left shoulder of the
tape side you want to protect.
– If “
CHECK TAPE
” is displayed, the
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening. Do not cover the Cr0
2
tape
detection hole when covering the tab
opening.
Recording from other sources
(only on tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load a blank tape into tape deck 2 with
the open side downward.
3 Press SIDE on remote control to select
the recording side.
™ The
BACK or FRONT flag will be
displayed, depending on the side
selected.
4 Press A. REV to select the playback
mode (
å å
å å
å or
∂∂
∂∂
∂ ).
5 Press CD, TUNER or AUX.
• Start playback of the selected source.
TIMER
STEREO
FM
BACK
HSD
REPEAT
LW
MW
AM
T.A.NEWS
SOUND NAVIGATION
DIGITAL SOUND
CONTROL
DYNAMIC BASS
BOOST
TAPECD
PROG
CLOCK/
TIMER
NEWS!
RDS
DOLBY B
NR
DUB
(HSD)
REC
STANDBY
ON
SIDE A•B
A.REV
TUNER AUX
PRESET
▲
▲
STOP•CLEARSEARCH • TUNING PLAY PAUSE PREV NEXT
MINI HIFI SYSTEM
CD1 • 2 • 3 CDRFM • AM TAPE 1 • 2
FRONT
60Hz
500Hz
250Hz
1KHz
2KHz
4KHz
8KHz
VOLUME
REC
SHUFFLE
PROGRAM
SS
LR
C
PRO LOGIC
SWITCH OFF DOLBY PRO LOGIC WHEN RECORDING
6 Press REC to start recording.
™ The
REC flag starts flashing.
7 Press Ç to stop recording.
Notes:
– Only
åå
åå
å
or
∂∂
∂∂
∂
mode is available
during recording .
– During recording, it is not possible to
listen to another source.
Dubbing tapes
(from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck
2.
™ Make sure that both tapes have their
full spool to the left.
3 Press SIDE on the remote control to
select the recording side.
4 Press DUB (HSD)
once
for normal
speed dubbing or
twice
(within 2
seconds)
for high speed dubbing.
™ “NORMAL” (normal speed) or
“FAST” (high speed) will be
displayed, followed by
“DUBBING”.
™ The
HSD flag appears on the display
during high speed dubbing.
• Dubbing will start immediately.
™ The
REC flag starts flashing.
5 Press Ç to stop dubbing.