Philips FW-V787 Stereo System User Manual


 
26
English
3140 115 30041
General Information on
Recording
If you do not intend to record via the
microphone, unplug the microphone to avoid
accidental mixing with other recording source.
For recording, use only tape of IEC type I
(normal tape).
The recording level is set automatically, regardless
of the position of the Volume, VAC, DSC and so
forth.
The tape is secured at both ends with leader
tape. At the beginning and end of the tape,
nothing will be recorded for six to seven
seconds.
To prevent accidental recording, break out the
tab on the left shoulder of the tape side you
want to protect.
If “CHECK TAPE” is displayed, the protection
tab has been broken. Put a piece of clear
adhesive tape over the opening.
IMPORTANT!
Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
Recording is possible only on tape deck 2.
Preparation for Recording
1 Press TAPE (TAPE 1•2) to select TAPE 2.
2 Load a recordable tape into tape deck 2 with full
spool to the left.
3 Prepare the source to be recorded.
VCD – load the disc(s).
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 1 with the full spool to the left.
AUX – connect external equipment.
When recording is in progress
starts flashing.
It is not possible to listen to another sources
except when dubbing tapes.
It is not possible to activate the timer function.
One Touch Recording/Recording
the mixed sound
1 Press VCD, TUNER or AUX to select the
source.
You can connect a microphone to record the
mixed sound in tape deck 2 (refer to “Karaoke -
Microphone Mixing”).
2 Start playback of the selected source.
3 Press REC to start recording.
To stop recording
Press Ç on the system.
Note:
One Touch Recording is not possible in TAPE
mode, "SELECT SOURCE" will be displayed.
CD/VCD/MP3-CD Synchro
Recording
1 Press VCD to select the disc.
Press í or ë to select the desired track to
start recording.
You can programme the tracks in the order you
want them to be recorded (refer to “CD/VCD/
MP3-CD Operation - Programming the disc
tracks”).
2 Press REC to start recording.
The disc will start playback automatically.
Tape Operation/Recording