Filter
Top Products
9
English
3140 115 31011
Preparations
C Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to "R" and left
speaker to "L", coloured (marked) wire to "+"
and black (unmarked) wire to "-".
1
2
● Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Notes:
–For optimal sound performance, use the supplied
speakers.
– Do not connect more than one speaker to any
one pair of
+
/
-
speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
D Video Out Connection
Connect the VIDEO OUT (CVBS) terminal
at the rear of the system to the TV or VCR
VIDEO IN for viewing or recording.
Note:
–To avoid magnetic interference with the picture
on your TV, do not position the front speakers too
close to the TV.
E Connecting other equipment to your
system
Connect the audio left and right OUT terminals
of a TV, VCR, Laser Disc player, DVD player or
CD Recorder to the AUX/CDR IN terminals.
Note:
– If you are connecting equipment with a mono
output (a single audio out terminal), connect it to
the AUX/CDR IN left terminal. Alternatively, you
can use a “single to double” cinch cable (still be
mono sound).
F Power Booster Connection
1 Connect the BOOSTER OUT (Right and Left)
terminals of the mini system to the power
booster amplifier BOOSTER IN (Right and
Left) terminals respectively.
2 Connect the speaker wires to the BOOSTER
SPEAKERS terminals, right speaker to "R" and left
speaker to "L", coloured (marked) wire to "+"
and black (unmarked) wire to "-".
3 Set the VOLTAGE SELECTOR to the local
power line voltage.
4 Plug in the AC mains to the wall socket.
5 Switch on the POWER SWITCH to activate
the power booster amplifier.
6 Press STANDBY ON y button to switch the
system ON or to Standby mode.
7 Rotate the VOLUME control to adjust the
loudness of the power booster amplifier.
Inserting batteries into the
Remote Control
Insert two batteries (Type R06 or AA) into the
remote control with the correct polarity as
indicated by the + and - symbols inside the
battery compartment.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances, so
they should be disposed off properly.
R
SPEAKERS 6Ω
+
–
–
+
BOOSTER IN
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
ON
POWER SWITCH
OFF
R
L
R
L
L
1
2 4
5
6
7
VOLUME
AC MAINS
VOLTAGE
SELECTOR
110V-
127V
220V-
240V
3