Filter
Top Products
3139 116 19441 (ENG)
12
Important:
Before you operate the system,
complete the preparation
procedures.
Demonstration mode
The system has a demonstration mode
that shows the various features offered
by the system. When the system is
switched on for the first time, the
demonstration mode will start
automatically.
Notes:
– During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
– When the system is switched to
standby mode, the demonstration will
resume five seconds later.
To stop the demonstration mode
• Press and hold Ç(on the system
only) for five seconds when the
system is in demonstration mode.
™ The demonstration will stop.
™ "DEMO OFF" is displayed.
™ The system will switch to standby
mode.
™ (for model FW-C70 only)
About five seconds later, the
system will go into an energy
saving mode ( < 2 watts ). The
low power STANDBY ON LED
will be lit.
Notes:
– When the system is switched on from
the main power outlet, the CD carousel
tray may open and close again to
initialize the set.
OPERATING THE SYSTEM
FRONT
FM
STEREO
BACK
HSD
REPEAT
REC
LW
MW
AM
T.A.
NEWS
TAPECD
PROG
CLOCK/
TIMER
NEWS!
RDS
DOLBY B
NR
STANDBY
ON
TUNER AUX
PRESET
▲
▲
STOP•CLEAR
SEARCH • TUNING
PLAY
PAUSE PREV NEXT
MINI HIFI SYSTEM
CD1 • 2 • 3
VIDEO
FM • AM
TAPE 1 • 2
TIMER
60Hz
500Hz
250Hz
1KHz
2KHz
4KHz
8KHz
VOLUME
SHUFFLE
PROGRAM
SS
LR
C
PRO LOGIC
UP
DOWN
SOUND
SOUND NAVIGATION
DIGITAL SOUND
CONTROL
DYNAMIC BASS
BOOST
– Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
To start the demonstration mode
• Press and hold Ç(on the system
only) for five seconds when the
system is in standby mode.
™ The demonstration will begin.
Easy Set
EASY SET allows you to store all
available radio stations automatically.
• Press and hold STANDBY ON (on
the system only) for five seconds
when the system is in standby or
demonstration mode.
™ “EASY SET” will be displayed,
and followed by “TUNER” and
then “AUTO”.
™ EASY SET will start searching for
all radio stations on FM band and
then followed by radio stations on
AM band.
™ All available radio stations with
sufficient signal strength will be
stored. Up to 40 presets may be
stored.
Notes:
– EASY SET will start with the FM band,
if there are still presets available, the
system will continue to store the AM
band.
– When EASY SET is used, all previously
stored radio stations will be replaced.
– The last preset radio station will
appear on the display when EASY SET
is completed.
Switching the system ON
• Press CD, TUNER, TAPE or AUX.
You can also switch on the system by
pressing any one of the CD DIRECT
PLAY buttons.
Switching the system to
standby mode
• Press STANDBY ON or B on
the remote control.
™ The system will switch to standby
mode.
™ (for model FW-C70 only)
About five seconds later, the
system will go into an energy
saving mode if the demonstration
mode has been disabled.
pg 01-28/C50-C70/37-Eng 18/11/1999, 2:38 PM12