Filter
Top Products
19
3139 116 17531
English
3 Press PAUSE on tape deck 1.
4 Press RECORD on tape deck 1.
5 Press PLAY on tape deck 2.
™ Recording will start automatically.
™ The REC flag starts flashing.
6 Press STOP•OPEN on tape deck 1 and tape deck 2 to
stop dubbing.
Notes:
– At the end of side A, flip the tapes to side B and
repeat the procedure.
– Dubbing of tapes is only possible from tape deck 2 to
tape deck 1.
– To ensure good dubbing, use tapes of the same length.
– During high speed dubbing in Tape mode, the sound is
reduced to a low volume.
CD Synchro Start Recording
During CD synchro start recording,
• It is not advisable to fast forward/rewind your tape in
tape deck 2.
• It is not possible to listen to another source.
1 Load a blank tape into tape deck 1 and a disc into the
disc tray.
2 Press CD.
• You can program the tracks in the order you want them
to be recorded (see Programming Tracks). If not, the
tracks are recorded according to the disc.
3 Press RECORD on tape deck 1 to start recording.
4 Press STOP•OPEN on tape deck 1 to stop recording
and STOP Ç to stop CD playback.
Recording from other sources
(only on tape
deck 1)
1 Load a blank tape into tape deck 1.
2 Press CD, TUNER or AUX.
• Start playback of the selected source.
3 Press RECORD on tape deck 1 to start recording.
™ The REC flag is flashing.
4 Press PAUSE to interrupt recording.
5 Press STOP•OPEN on tape deck 1 to stop recording.
Note:
– During recording, it is not possible to listen to another
sound source.
View Clock
You can view the clock (if it is set) at standby or any
source mode. It will be displayed for about 7 seconds.
• Press CLOCK•TIMER briefly.
™ “10:25” (the current time) will be displayed.
™ “--:--” will be displayed if the clock is not set.
Clock Setting
The clock is set in 24-hour mode, e.g. “00:00“ or
“23:59“. Before setting the clock, you must be in the
View Clock mode.
1 Press CLOCK•TIMER to select clock mode.
™ “00:00” or the current time starts flashing.
™ “à , á , í , ë, Ç” light up
(for models
FW325 and FW326 only).
2 Set the hour with à or á.
3 Set the minute with í or ë.
4 Press CLOCK•TIMER again to store the setting.
™ The clock starts running.
• To exit without storing the setting, press STOP Ç.
Notes:
– During clock setting, if no button is pressed within 90
seconds, the system will exit clock setting mode
automatically.
– When a power interruption occurs, the clock setting is
erased.
– To set the time with RDS clock, see "Receiving RDS
Radio Station" under TUNER section. (for model
FW326 only)
RECORDING CLOCK
pg 01-22/FW326/22-Eng 12/9/98, 15:5419