Filter
Top Products
13
3139 116 17531
English
Selecting a desired track during playback
1 Press PREV í or NEXT ë until the desired track
appears on the display.
™ The selected track number and elapsed playing
time appear on the display.
• If you press PREV í once it will skip to the
beginning of the current track and play the track again.
Searching for a particular passage
during playback
• Press and hold à or á until the desired passage is
located.
™ The volume will be reduced.
• Play returns to normal when à or á is released.
Programming Tracks
Programming tracks of a loaded CD is possible in the stop
mode. The display will indicate the total tracks stored in
the program. Up to 20 tracks can be stored in the memory
in any order. When 20 tracks are stored and you attempt
to store another track, the display will show “PROGRAM
FULL”.
1 Load the desired disc in the disc tray.
2 Press PROGRAM to start programming.
™ The PROGRAM flag starts flashing.
3 Press PREV í or NEXT ë to select the desired
track.
4 Press PROGRAM to store the track.
• Repeat steps
3
to
4
to store other tracks.
5 Press STOP Ç once to end programming mode.
™ The total number of tracks programmed and total
playing time appear on the display.
Notes:
– If the total playing time is more than “
99:59
” or if
one of the programmed tracks has a number greater
than 30, then “
--:--
” appears in the display instead
of the total playing time.
– During programming, if no button is pressed within 20
seconds, the system will exit program mode
automatically.
Playing the program
1 Press PLAY É to start program playback.
™ “PLAY PROGRAM” appears on the display.
™ The track number and elapsed playing time of the
current track will appear on the display.
• If you press REPEAT during program playback, the
current track will be played repeatedly.
™ The REPEAT and PROGRAM flags will be displayed.
2 Press STOP Ç to stop program playback.
Reviewing the program
Reviewing of the program is only possible in the stop
mode.
• Press PREV í or NEXT ë repeatedly to review the
programmed tracks.
• Press STOP Ç to exit review mode.
Erasing the program (in the stop mode)
• Press CLEAR on the system.
™ “PROGRAM CLEARED” will be displayed.
Note:
– The program will be erased when the system is
disconnected from the power supply. If the CD tray is
opened, the program will be erased and the display
will show “
PROGRAM CLEARED
” .
Shuffle
(only on remote control)
It will play all the tracks in random order. Shuffle may
also be used when tracks are programmed.
To shuffle all the tracks
1 Press SHUFFLE.
™ “SHUFFLE” will be displayed.
™ The SHUFFLE flag, the track selected at random
appears on the display.
• The tracks will now be played in random order until
you press STOP Ç.
• If you press REPEAT during shuffling, the current track
will be played repeatedly.
™ The REPEAT and SHUFFLE flags will be displayed.
2 Press SHUFFLE again to resume normal playback.
™ The SHUFFLE flag disappears from the display.
Repeat
(only on remote control)
It will play the current track repeatedly.
1 Press REPEAT during CD playback.
™ “REPEAT TRACK” will be displayed.
™ The REPEAT flag appears on the display.
• The track will now be played repeatedly until you
press STOP Ç.
2 Press REPEAT again to resume normal playback.
™ The REPEAT flag disappears from the display.
CD
pg 01-22/FW326/22-Eng 12/9/98, 15:5413