Philips FW45C Stereo System User Manual


 
19
English
Tuning to radio stations
1 Press TUNER to select TUNER mode.
"TUNER" will be displayed.
A few seconds later, the current frequency is
displayed.
2 Press TUNER (BAND) again to select the desired
waveband : FM or AM.
3 Press TUNING à or á for more than one second,
then release.
The display will show ‘SEARCH’ until a radio station
with sufficient signal strength is found.
Repeat this procedure until the desired station is
reached.
To tune to a weak station, briefly press TUNING à or
á until the display shows the desired frequency and/or
when the best reception has been obtained.
Storing Preset Stations
You can store up to 40 radio stations in the memory. When
a preset radio station is selected, the preset number
appears next to the frequency on the display.
Automatic programming
1 Press TUNER.
2 Press TUNER (BAND) again to select the desired
waveband : FM or AM.
3 Press PROGRAM for more than one second.
PROGRAM flag starts flashing and ‘AUTO’ will be
displayed.
Every available station for the selected waveband
will be stored automatically. The frequency and
preset number will be displayed briefly.
The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
The system will remain tuned to the last stored
preset radio station.
Repeat the above procedure to store other preset radio
stations for the other waveband. Remember to select
the next available preset number before proceeding. If
not, some of the preset radio stations may be erased.
Notes:
You can cancel the automatic programming by pressing
PROGRAM or STOP•CLEAR
Ç
on the system only.
If you want to reserve a section of preset numbers, for
example preset numbers 1 to 9, select preset 10 before
starting automatic programming: now only the preset
numbers 10 to 40 will be programmed.
Manual programming
1 Press TUNER.
2 Press TUNER (BAND) to select the desired waveband :
FM or AM.
3 Press PROGRAM for less than one second.
PROGRAM flag, the frequency and preset number
start flashing.
The next available preset number will be displayed
for selection.
4 Press TUNING à or á to tune to the desired
frequency.
If you wish to store the radio station to another preset
number, press PRESET 4 or 3 to select the desired
preset number.
5 Press PROGRAM again.
PROGRAM flag will stop flashing, and the radio
station will be stored.
TUNER
Repeat the above procedure to store other preset radio
stations.
Notes:
When 40 radio stations are stored and you attempt to
store another radio station, the display will show
"
PROGRAM FULL
”. If you want to change an
existing preset number; repeat steps 4 and 5.
You can cancel manual programming by pressing
STOP•CLEAR
Ç
on the system only.
During programming, if no button is pressed within 20
seconds, the system will exit program mode
automatically.
Tuning to Preset Radio Stations
Press PRESET 4 or 3 to select the desired preset
number.
The preset number, frequency and waveband appear
on the display