Filter
Top Products
13
Set clock
1 In standby mode, press CLOCK/
DISPLAY on the remote control to
activate the clock setting mode.
» The hour digits are displayed and begin
to blink.
2 Press / to set the hour.
3 Press CLOCK/DISPLAY.
» The minute digits are displayed and
begin to blink.
4 Press / to set the minute.
5 Press CLOCK/DISPLAYtoconrm.
Turn on
Press .
» The unit switches to the last selected
source.
Switch to standby
Press again to switch the unit to standby
mode.
» The clock (if set) appears on the
display panel.
Switch to ECO standby mode:
Press and hold for more than 3 seconds.
» [ECO STANDBY] (Eco standby) is
displayed for 3 seconds and then
disappeared.
Tip
• The unit switches to Eco Power Standby mode
after 15 minutes in standby mode.
Switch between standby mode and ECO
standby mode:
Press and hold for more than 2 seconds.
Prepare the remote control
Caution
• Risk of explosion! Keep batteries away from
heat,sunshineorre.Neverdiscardbatteries
inre.
To insert the remote control battery:
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
• If you are not going to use the remote control
for a long time, remove the batteries.
• Do not use old and new or different types of
batteries in combination.
• Batteries contain chemical substances, so they
should be disposed of properly.
a
b
c
English
EN