Philips AZ 1025 Stereo System User Manual


 
TROUBLESHOOTING
16
The type plate is located on the bottom of the set.
English
AZ 1025 /17 page 16
PROBLEM
POSSIBLE CAUSE
REMEDY
No sound/power
VOLUME is not adjusted
Adjust the VOLUME
Headphones are connected
Disconnect headphones
Power cord not securely connected
Connect the AC power cord properly
Batteries exhausted/incorrectly inserted
Insert fresh batteries/ batteries correctly
Batteries loaded but power cord still plugged
in and connected
Detach the power plug from the MAINS jack
and the set
Poor radio reception
Weak radio signal
FM: extend and aim the telescopic antenna
for best reception;
AM: rotate the set
CD playback does not work
CD is badly scratched or dirty
Replace or clean the CD, see Maintenance
Laser lens steamed up
Wait until lens has acclimatized
The CD skips tracks
CD is damaged or dirty
Replace or clean the CD
SHUFFLE or PROGRAM is active
Quit SHUFFLE/PROGRAM mode(s)
Poor cassette sound quality
Dust and dirt on the heads, etc
Clean deck parts etc., see maintenance
Use of incompatible cassette types (METAL
or CHROME)
Only use NORMAL (IEC I) for recording
Recording does not work
Cassette tab(s) may be broken out
Apply a piece of adhesive tape over the
missing tab space
Remote control does not function properly
Batteries exhausted/incorrectly inserted
Insert fresh batteries/ batteries correctly
Distance between the set too large
Reduce the distance
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable
to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock! Under no
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
Environmental information
We have reduced the packaging to the minimum and made it easy to separate into three materials:
cardboard (box), expandable polystyrene (buffer), and plastic (bags, protective foam).
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
XP AZ 1025/17 19-09-2000 13:02 Pagina 16