Filter
Top Products
DIGITAL TUNER
10
MW (AM) TUNING STEP (SOME VERSIONS ONLY)
In North and South America the frequency step between adjacent
channels in the AM band is 10 KHz. In the rest of the world this
step is 9 KHz. Usually this frequency step has been preset in the
factory of your area.
To change the tuning step
1. Adjust the CD TUNER TAPE/
OFF slider to TAPE/OFF position.
2. Press and hold down on BAND and SEARCH ∞ simultaneously
to select 9 KHz.
3. Adjust the CD TUNER TAPE/
OFF slider to TUNER position and
then release the BAND and SEARCH ∞ controls.
™ All preset stations will be lost and need to be programmed
again.
• To select 10 KHz, repeat steps 1-3 but use SEARCH §
instead.
TUNING TO RADIO STATIONS
1. Adjust the CD TUNER TAPE/
OFF slider to TUNER position.
2. Press BAND to select your wave band.
To tune to radio stations, press the SEARCH or TUNING
controls ∞ or § until the frequency in the display starts
running, then release the control.
™ Srch appears in the display and the radio automatically
tunes to a station of sufficient reception.
3. Repeat if necessary until you find the desired station.
• To tune to a weak transmitter, briefly press SEARCH ∞ or
§ until you have found optimum reception or the correct
frequency.
™ When
STEREO appears in the display, you are receiving a FM-
stereo transmitter.
To improve radio reception
• For FM, pull out the telescopic antenna. Incline and turn the
antenna. Reduce its length if the signal is too strong (very
close to a transmitter).
• For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
English
AZ 1025 /17 page 10
TUNER
TUNER
FM
C
D
S
Y
N
C
H
R
O
S
T
A
R
T
R
E
C
O
R
D
I
N
P
A
U
S
E
S
V
O
L
U
M
E
C
D
S
Y
N
C
H
R
O
S
T
A
R
T
R
E
C
O
R
D
V
O
L
U
M
E
SHU
FFLE
FM
TU
NE
R
R
E
PE
A
T
SHUFFLE
BAND
P
R
E
S
E
T
S
P
R
O
G
AZ1025
XP AZ 1025/17 19-09-2000 13:02 Pagina 10