Filter
Top Products
Recording
RECORDING
Copyright:
Recording is permissible insofar as copyright
or other rights of third parties are not infringed.
Safeguarding a cassette against erasure:
Accidental erasure can be prevented by
breaking the small tab in the top corner of the
back of the cassette.
This protection can be reversed
with a piece of adhesive tape
placed over the same corner.
Winding the tape
• Press F.FWD 5 to fast forward the tape.
• Press REW 6 to fast rewind the tape.
• Press STOP 9 to stop fast forward or fast-
rewind, or before the end of the tape.
RECORDING (on deck 2 only)
• Press EJECT / to open the cassette holder.
• Insert the cassette into deck 2.
For recording you must use a
NORMAL cassette (IEC I) on
which the tabs have not been
broken.
At the very beginning of the tape, no
recording will take place during the first
seven seconds when the leader tape passes
the recorder heads.
• When monitoring during recording, adjust
the sound with the controls VOLUME and
TONE. These controls do not affect the
recording.
• To stop, Press STOP 9.
RECORDING FROM THE RADIO
• Set the TAPE/RADIO selector to RADIO.
Mono recording from the built-in
microphone
• Set the TAPE/RADIO selector to TAPE
• Set the VOLUME control to the minimum
volume level (during microphone recordings,
monitoring is not possible)
STARTING AND STOPPING THE
RECORDING
• To start recording, press RECORD 0 and
PLAY 1 is then pressed at the same time.
– When the end of the tape is reached, the
recorder buttons are released.
• To interrupt recording, press PAUSE ;.
• To continue recording, press PAUSE ; again.
• Press STOP 9 if you want to stop the
recording before the end of the tape. On
pressing again, the cassette holder will
open.
• The set is switched off if the TAPE/RADIO
selector is in position TAPE and no buttons
are pressed.
DUBBING – Copying from deck 1 to 2
When dubbing, it is recommended to use
fresh batteries or to connect the set to the
mains supply.
• Set the TAPE/RADIO selector to:
– DUBBING - for normal speed copying
– HI-SPEED DUBBING - for high speed
copying
Do not switch this selector during dubbing.
• Press both EJECT / buttons and insert a
recorded cassette into deck 1 and a
cassette which is suited for recording into
deck 2.
• Press PAUSE ; followed by RECORD 0 on
deck 2.
• To start dubbing, press PLAY 1 on deck 1.
• Press PAUSE ; on deck 2 if you wish to
omit undesired passages and the playback
in deck 1 will continue. To restart dubbing,
press PAUSE ; again.
• By pressing PAUSE ; in deck 1 during
dubbing, a blank part will be recorded in
deck 2.
• To stop dubbing, press both STOP buttons
9. The set is then switched off.
1
7
English
AW 7150/AW 7250/00. page 7