Filter
Top Products
7: Signal Error Rate: If the transmisstion
signal contains errors, the system can apply
correction.The amount of signal correction
can be displayed as a numerical value
between 0 and 99.As the value increases, the
signal will be degraded.To improve reception,
try adjusting the position of the antenna.
Using the MENU control
The menu control lets you access the DAB
radio setup options.
1 In DAB mode, press MENU to enter the
menu options.
➜ The first setup option "Manual tune" is
displayed.
2 Press
1 / 2 to scroll up and down the menu
options:
Manual tune -> Autoscan local -> Autoscan
full - > Clock - > DRC value -> Sw version
3 To select an option, press SELECT.
4 Repeat steps 2-3 if sub-option is available
under one option.
Helpful hints:
– In FM/AUX IN mode,when you press MENU
there are only two options: Clock and Sw
version.
Manual tune
By using this feature, it is possible to manually
tune to a specific channel/frequency. In addi-
tion to antenna orienting for better radio
reception, the optimum reception can also be
obtained by using this feature.
1 In DAB mode, press MENU to display
"Manual tune" option.
2 Press SELECT to make a selection.
➜ Display shows a channel and its frequen-
cy.
3 Press
1 / 2 repeatedly until desired
channel/frequency appears.
4 Press SELECT to confirm the selection.
➜ The second line of the display shows the
selected channel and its frequency.The
first line of the display shows a rectangle.
The position of the rectangle indicates
the degree of signal strength (The further
towards the right, the greater the signal
strength
. See
4
)
.
5 Adjust the position of the antenna to obtain
the optimum signal strength.
6 Press SELECT to return to normal display.
➜ You may press DISPLAY to change the
service information on the display.
CLOCK
CLOCK lets you enter time and alarm setting
options:
1 In DAB/FM/AUX IN mode, press MENU to
enter menu options.
2 Press
1 / 2 repeatedly until “Clock” appears.
3 Press
SELECT
to confirm the setting.
4 Press 1 / 2 to select the options:
Set alarm - >Alarm On/Off - >
Snooze- > Sleep- > Auto-set Clock- >
Set clock- >kitchen time
– “Auto - set clock” option is not available in
FM or AUX IN mode.
5 Press
SELECT
to confirm the setting.
Set alarm
Make sure you have correctly set the time
before you set the alarm.
1 In “Set alarm” mode, press 1 / 2 to set time
➜ Press
SELECT
to switch hour setting to
minute setting.
2 Press
SELECT
to confirm the setting.
➜ “Alarm source” appears.
3 Press 1 / 2 to select the alarm sound source:
DAB - > FM - > BUZZER
➜ “Set alarm date” appears.
4 Press
1 / 2 to select the options:
Once- > Daily
5 Press SELECT to confirm the setting.
DAB Radio
AE5900_05_CCR 2007.8.31 14:44 Page 8