Filter
Top Products
6 Pelco Manual C806M (3/97)
4.0 INSTALLATION
1. With the front panel off, find a suitable opening in the console and insert the
VCR rack mount carefully.
2. Holding the mount in place, align the holes on the rack and start each of the
(4) 10-32 screws. Tighten the screws.
3. Make all necessary connections to the VCR and slide it into the opening until
the rear feet of the VCR rest against the lip at the back of the base.
The front panel can now be installed by placing the tabs in their corresponding slots
on the base panel and engaging the latch.
5.0 SPECIFICATIONS
The RM2100/2196 requires a minimum rack opening of 7.00" (17.78 cm).
Dimensions
VCR Compartment
Dimensions: 5.75" H x 17.15" W x 13.80" D (14.61 cm x 43.56 cm x 35.05 cm)
Overall
Dimensions: 7.00" H x 19.00" W x 14.40" D (17.78 cm x 48.26 cm x 36.58 cm)
Window
Dimensions: 4.00" x 18.00" (10.16 cm x 45.72 cm)
Construction
Rack mount: 16-gauge cold rolled steel
Front Panel: 16-gauge cold rolled steel with 1/4" (.63 cm) thick Smoked
Lexan Window w/ locking latch
Finish: Black polyester powder coat
Unit Weight: 7.188 lb (3.26 kg)
Maximum
Load Capacity: 25 lb (11.25 kg)
Figure 2. RM2100/2196 Dimension Drawing
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS;
ALL OTHERS ARE INCHES
REMINDER:
The RM2100/2196
requires a minimum rack opening
of 7.00" (17.78 cm).
CAUTION:
The front panel is not
permanently attached to the rack
mount and is therefore not sup-
ported when unlatched.