Filter
Top Products
Pelco Manual C806M (3/97) 5
2.0 DESCRIPTION
The RM2100/2196 VCR Rack Mount Kit has been specifically designed to provide
rack mounting and security for GYYR
™
Model TLC2100 and TLC2196 time-lapse
video recorders. The design of the RM2100/2196 VCR Rack Mount allows the cus-
tomer complete removal of the front panel for easier installation and better access
to the VCR. A locking knob on the front panel allows access to the VCR with or
without the key. The RM2100/2196 can be easily mounted using four (4) 10-32 x 3/
8" pan head screws (not supplied).
3.0 ASSEMBLY
Refer to Figure 1 during assembly.
1. Place the base (3) on a flat, stable surface. Allow the front to overhang the end
of the surface.
2. Interlock the side panels (1 & 2), one panel at a time. Lift the base and insert
the (5) tabs for the corresponding side panel into the base and rotate the side
panel up.
3. Secure the cross bar (4) to complete the assembly. Make sure the cutout on
the cross bar faces front.
a. Line up the middle tab at the ends of the cross bar with the slots on top of
the side panels.
b. Push in the middle tab (A) on the cross bar away from the side panel,
while pushing down, until the tab snaps into the slot on the side panel.
c. Repeat step b for the other end of the cross bar.
Do not install front panel at this time.
The VCR Rack Mount is ready to install.
NOTE:
The RM2100/2196 is de-
signed for front loading VCRs only
and will fit any standard 19 inch
(48.26 cm) rack.
Figure 1. RM2100/2196 Exploded Assembly
NOTE:
For ease of assembly,
both side panels should be in posi-
tion, perpendicular to the base,
before the cross bar is snapped into
place.