16 C2458M-E (10/06)
iPAQ Pocket PC Installation and Operation
To interface with a Spectra dome drive or IPS-RDPE-2 remote data port using a iPAQ Pocket PC, first
install the Control/Upload Utility and then install the IPS-CABLE.
The Control/Upload Utility is compatible with the following:
iPAQ Pocket PC 3100 series through 3800 series with Windows CE 3.0 for PocketPC or PocketPC
2002
Devices other than iPAQ that use Windows CE 3.0 for PocketPC or PocketPC 2002 should be
compatible.
NOTE: Know how to operate an iPAQ pocket PC before attempting to control or upload software
using the IPS-CABLE.
INSTALL THE CONTROL UTILITY FOR WINDOWS
1. Insert the Resource CD into the CD drive. The main menu appears on the monitor.
2. Connect the iPAQ to the PC.
3. Click the Install Control/Upload Utility button. The Install Shield Wizard starts. Follow the
instructions displayed on the monitor.
INSTALL THE CABLE
To install the IPS-CABLE, refer to Figure 3 and do the following:
1. Connect a null modem cable (not supplied) to the serial port on the Pocket PC.
2. Connect the 9-pin male connector from the IPS-CABLE to the null modem cable.
3. Connect the IPS-CABLE to the RJ-45 port of the Spectra dome drive or IPS-RDPE-2.
NOTE: When connected, the IPS-CABLE will interrupt control from the normal control source.