Peavey VSX 26 Speaker User Manual


 
17


3 inputs/6 outputs RTA Mic input can be summed with
Line inputs.

2 inputs/6 outputs LED STATUS:
Red = -0.5 dBFS and higher (Clip)
Red & Green = -4 to -0.5 dBFS
Green = -4 to -40 dBFS
Off = below -40 dBFS

Front panel switch and LED for each input and
output
LED STATUS:
Red = Muted
Off = On


-6 to +6 dB Software controlled

+24 dBu or -10 dBV Software selectable

4.4 k ohms Electronically balanced

24 dB

55 dB

-90 dB 20 Hz to 20 kHz

110 dB A-weighted 150 ohm input termination

+20 to +60 dB Approximately 1/2 dB steps

+2 dBu (.98Vrms) Gain = 60 dB, 22K BW

2.2 k ohm Electronically balanced

55 dB

-128 dB A-weighted 150 ohm input termination

+48 volts Software controlled

On XLR 1 Software selectable between left
channel analog line input


+24 dBu Balanced

150 ohms Electronically balanced

600 ohms Maximum output @ 600 ohms =
22.5 dBu

105 dB A-weighted



0.007 % 20 Hz to 20 kHz, 22 kHz BW filter,
+4 dBu signal with 20 dB headroom

20 Hz to 20 kHz ± 0.5 dBr referenced at 1 kHz

105 dB A-weighted, 150 ohm input
termination

< 1 mS Propagation delay from input to
output



