Filter
Top Products
CSTM
1800G FEATURES
l
19”
rack-mountable
design
requiring
two rack spaces
l
Automatic
two-speed
dual fan
cooling
system
l
Separate
power
transformers/circuit
breakers
for
each
channel
l
Independent
channel
thermal/fault
protection
l
DDTTM
activation
LED
and
power
LED, each
channel
l
Calibrated/detented
input
attenuator
controls,
each
channel
l
Two
recessed
balanced
input
transformer
sockets
for
PL-2’s
l Single
XLR
and
dual
phone
plug
inputs,
each
channel
l
XLR
input
can
be
transformer
balanced
l
Dual
phone
plug
and
5way
binding
post
outputs,
each
channel
l
Rear
panel
DDT
TM
defeat, mode select,
and
ground
lift
switches
Peavey Electronics is proud to announce the introduction of a new line of exciting Professional Power Ampli-
fiers. The new CS-G series is the result of years of research
&
development into a smaller, lighter, compact and more
powerful amplifier. These units operate much more efficiently than contemporary power amp designs, requiring less
current from the mains power plug, producing far less heating. This new technology allows the
CS’rM
1800G
to reliably
produce more than 1800 W RMS into 4 ohms (Bridge Mode) in a two rack space unit, at extremely low distortion
levels.
These new designs use a new class of operation called “Class BG”. This class uses two levels of power supply
“rails,” but switches between the rails faster and at lower distortion levels than does a typical Class G design. This unit
then combines higher efficiency and lower distortion, and together with our all new Non-saturating Series Single
Emitter Resistor topology (NSSER), provides awesome performance levels with full power 20 kHz distortion below
0.04%, and with slew rates greater than 40
V/@ec.
This technology is called “Dynamic Logic” and is covered by a
U.S. Patent (Pending).
The following is the new CS 1800G specs:
600 W RMS into 4 ohms; 900 W RMS into 2 ohms, per channel
1200 W RMS into 8 ohms; 1800 W RMS into 4 ohms (Bridge mode)
Slew Rate: 40 V/microsecond, stereo mode, each channel
Frequency Response: 20 Hz to 20 kHz, f0.2 dB, at rated power
Total Harmonic Distortion: Less than 0.04%, at rated power
Hum and Noise: 100 dB below rated power, unweighted
The unit is attractively packaged in a rugged, rack-mountable configuration requiring only two rack spaces.
Naturally it has Peavey’s patented DDT
TM
Compression Circuitry, and has a very flexible back panel. The design uses
dual two speed fan cooling to provide all the cooling necessary for the two ohm load conditions.