Filter
Top Products
EU 112D & EU 115D Access Text P0900080, P0900081 69601387
Impulse Access Text P0800053 69601387
5
CIRCUIT BREAKER (1)
The unit is AC power line protected from overloads and fault conditions with a 5 amp circuit breaker. This
breaker should not trip unless there is a fault in the amplifier circuitry or an abnormal operating condition which
causes excessive mains current to flow. If the breaker trips, set the Power switch (3) to OFF, wait a brief period
of time for the breaker to cool, then reset the breaker.
If the circuit breaker trips, the center button will pop outward approximately 1/4”, and can be reset by pushing
upward and inward. Under normal (not tripped) conditions, the center button is relatively flat.
If the unit continues to trip the breaker, or trips it immediately after being reset, do not keep resetting it. The
system should be taken to a qualified Peavey Service Center for repair.
IEC POWER CORD CONNECTION (2)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important that
you ensure the proper AC line voltage is supplied to the Impulse
®
12D. You can find the proper voltage for your
Impulse
®
12D printed next to the IEC line (power cord) on the rear panel of the unit.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never
break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are
properly grounded.
Applications
The Peavey Impulse
®
12D has a variety of applications, including sound reinforcement, public address, side
fill system, karaoke and musical playback.
A typical signal source for the line-level inputs of the Peavey Impulse
®
12D would be a sound
reinforcement mixing console (mixer) or the output from a CD player, MP3 player or tape deck. A dynamic
microphone can be connected directly and used as well.
REAR PANEL BOTTOM
our patented DDT
™
compression, which virtually eliminates audible power amplifier clipping. Cooling is via natural air
convection - no noisy fan!
Molded-in hand grips on either side of the front and a full handle on the right side provide ease of transport, while multiple
mounting points (top, bottom and right side) for the Peavey Versamount
™
70 Plus mounting bracket allow maximum utility.
The combination of the signal-processed servo-controlled woofer with the ribbon tweeter provides a clarity and impact
far beyond conventional powered enclosures. The Class D power amps and switch-mode power supply, along with the
neodymium magnet systems on the drivers, provide this high level of technological sophistication at a very light weight and
very reasonable cost.
1
3
2