Filter
Top Products
5
Introduction
Congratulations and thank you for your purchase of this precision Parasound audio
component. The Parasound Zamp v.2 is designed for a wide variety of applications,
including multi-room, multi-zone installations, desktop audio, bedroom or den systems.
The incredible versatility of the Zamp v.2 allows many connection and configuration
options, so please be sure to read this manual thoroughly before you begin installation.
Unpacking
Carefully unpack your Zamp v.2, remove the enclosed AC power cord and the sub-mini
2.5 mm trigger connection plug and wire. Be sure to inspect the unit for any possible
shipping damage. If you notice any, contact your Parasound Dealer immediately. Save the
carton and all of the packing materials in case you ever need to ship your amplifier for
repair. Before you proceed, locate the serial number on the rear panel or underside of the
unit and record it here for future reference:
Serial #_____________________________ Purchase Date _____________________
Parasound Dealer ____________________ Phone Number _____________________
Installation and Rack Mounting
Install your Zamp v.2 away from heat sources such as heating ducts and radiators. Always
mount the amplifier horizontally.
Its panel dimensions are one rack space high (1 3/4" or 44 mm) by one-half rack space
wide (9 1/2" or 242 mm). It will fit into a standard 19" wide equipment rack when
mounted side-by-side with other Parasound half-width components. Optional accessory
parts are available from Parasound to rack mount the Zamp v.2 by itself or alongside
another Parasound half width unit.
Ventilation Requirements
The Zamp v.2 can generate substantial heat and requires adequate ventilation to prevent
overheating and shut down by its thermal protection circuit. Observe the following
ventilation guidelines when installing the Zamp v.2 in a cabinet or other enclosed area:
1) If you are not using a ventilation fan, allow few inches on each side and above the
unit. You should never install the Zamp v.2 in an unventilated equipment cabinet with a
door or panel because hot air cannot exhaust adequately.
3) Do not place the Zamp v.2 on carpeting or any other material that could obstruct
airflow through the ventilation holes in the bottom of its chassis.
4) Try to avoid stacking the Zamp v.2 tightly between other components because the heat
it produces will not dissipate adequately and may cause overheating of the amplifier and
the other units.