Filter
Top Products
4
If you turn the JC 2 BP volume control knob manually while Bypass is selected you will not
hear a volume change. But you did make a new volume setting and it will be instantly audible
when you select a non-Bypass input. The resulting blast of sound could be loud enough to
damage your speakers.
How to Cancel or “Un-assign” Bypass
Once you have assigned an input for Bypass mode it is possible to revert that input back to
normal operation. You will only need to do this if you change the way you have connected your
surround processor or receiver.
..Please be sure the JC 2 BP volume control knob is turned down before proceeding..
If you turned the volume knob manually to a new position while an input assigned for Bypass
was selected you did not hear any volume change. However, the new volume level will be
instantly audible when you restore the Bypass input to its normal, non-Bypass, function. The
resulting blast of sound could be loud enough to damage your speakers.
To cancel the Bypass mode for any input, repeat the same procedure as the Bypass
assignment:
1- Press the “B” key
2- Press the “P” key
3- Press the Input number key for the input you want to revert to normal function
When the Bypass assignment is canceled the amber Bypass indicator will no longer glow.
Note: If you accidentally press the wrong input number key that input will now be assigned to
the Bypass function. You can cancel it by first pressing “B” key, then “P” key and finally the
input number key you mistakenly selected.
Copyright 2010 Parasound Products, Inc. All rights reserved. v1.0
w
w
w
w
w
w
.
.
p
p
a
a
r
r
a
a
s
s
o
o
u
u
n
n
d
d
.
.
c
c
o
o
m
m
