Filter
Top Products
12
■ WX-C516 Power Transformer
#3 Mounting Hole
This hole is used for mounting the power transformer
onto the wall plates.
#4 Power Plug
To prevent fire or electrical shock, connect this directly
to a 3-plug grounded receptacle of 120 V AC, 60Hz.
#5 Output terminal (SPARE, AC, AC, GND)
12 V AC, 1 600 mA (UL Listed) is provided at the two
terminals (indicated as "AC") to be used for the center
module.
Caution:
Be sure to connect the wire between the GND
(GROUND) of this terminal and that in the trans-
former terminal on the center module.
To prevent fire or electrical shock, the UL listed
power supply cord (Style SVT) should be used for
the cable for 12 V AC terminal.
■ WX-C550 Speaker Microphone
$0$1
#3
#4
#5
#6 Input Cord
A pigtail cord is provided for the speaker input. Its
length is approx. 3 meters.
#7 Mounting Bracket
AU-type mounting bracket with screw holes is provid-
ed as a standard accessory with the WX-C550.
WX-CC2010
T
R
A
N
S
C
E
IV
E
R
M
O
N
IT
O
R
ULTRAPEX II
POWER
VEHICLE
PRESENT
DNRDNR
A
B
POWER
VEHICLE
PRESENT
Antenna
Standard Accessory
Memo Label
Standard Accessory
• Mount the antenna.
• Write down DIP switch
settings if necessary.