Filter
Top Products
6
RQTX0210
Quick Start Guide
Getting Started
Preparation
≥To prevent damage or scratches, lay down a soft cloth to assemble speakers.
≥For assembly, use a Phillips-head screwdriver (not included).
≥You will need to obtain the appropriate screw eyes to match the walls
or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the appropriate
procedure when attaching to a concrete wall or a surface that may not
have strong enough support. Improper attachment may result in
damage to the wall or speakers.
e.g. Front speaker
Caution
Do not stand on the base. Be cautious when children are near.
step 1 Assembling the front speakers
Speaker assembly option
Make sure you have all the indicated components before starting assembly, setup, and connection.
≥Keep the screws out of reach of children to prevent swallowing.
≥For optional wall mount, refer to page 27.
2 Bases 8 Screws2 Front speakers 2 Stands (with cable)
1
2
2
1
Tighten securely.
Slide into the groove.
Position the cable
between the ridges.
Tighten securely.
Press into the groove.
Insert the wire fully.
i: White
j: Blue
Push!
Leave about 120 mm (4
23
/32z)
Leave about
120 mm (4
23
/32z)
You can remove and use the
cable from the stand. To reattach
the cable, refer to page 27.
Insert the wire fully.
i: White
j: Blue
Push!
Tighten securely.
Press into the groove.
Thread the speaker cable through
the base.
Attach the speaker.
Slide into
the groove.
Preventing the speakers from falling
String (not included)
Thread from the wall to the speaker and tie tightly.
Rear of the
speaker
Wall
Approx.
150 mm
(5
29
/32z)
Screw eye
(not included)
DO
NOT
e.g. Front speaker
RQTX0210-1P_670-673_Eng.book Page 6 Friday, April 3, 2009 2:48 PM