Filter
Top Products
11
RQTX0210
Getting Started
Quick Start Guide
Conserving power
The main unit consumes a small amount of power when it is turned off
(approx. 0.1 W.). To save power when it is not to be used for a long time,
unplug it from the household AC outlet.
You will need to reset some memory items after plugging in the main
unit.
[Note]
The included AC power supply cord is for use with the main unit only. Do
not use it with other equipment. Also, do not use cords for other
equipment with the main unit.
≥Use alkaline or manganese batteries.
≥Do not heat or expose to flame.
≥Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
Do not:
≥mix old and new batteries.
≥use different types of batteries at the same time.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
Aim at the remote control signal sensor (B 39), avoiding obstacles, at a
maximum range of 7 m (23 ft) directly in front of the unit.
step 4 AC power supply cord connection
AC IN
Main unit
AC power supply cord
(included)
To household AC outlet
step 5 Preparing the remote control
Batteries
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
R6/LR6, AA
Insert so the poles ( and ) match those in the remote control.
Press in and lift up.
Replace the cover.
Use
RQTX0210-1P_670-673_Eng.book Page 11 Friday, April 3, 2009 2:48 PM