Panasonic SC-HTB70 Home Theater System User Manual


 
Operations
RQT9763
21
Depending on your preference, It is possible to turn off the
3D surround effect and the clear-mode dialog effect.
While pressing and holding [SOUND]
on the remote control, press and
hold [VOL i] on the main unit for
more than 4 sec.
While the setting is displayed, press
[SOUND] to change the setting.
The setting changes each time [SOUND] is pressed.
The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
This setting will be reset to on when the main unit is turned
off.
When off is selected, the dialog effect level cannot be
adjusted.
You can turn off dimmer mode and keep the LED
indicators bright.
While pressing and holding [INPUT
SELECTOR] on the remote control, press
and hold [s VOL] on the main unit for
more than 4 sec to turn off Dimmer mode.
The indicator for the current condition will turn brighter.
The setting is maintained until it is changed again.
Default setting of this function is on.
To turn on dimmer mode, repeat the operation above.
After performing the operation, the indicator for the current
condition will be dim.
Remote control code
When other Panasonic devices respond to this system’s
remote control, change the remote control code on this
system and the remote control.
Preparation
Turn off all other Panasonic products.
Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at the main unit’s
remote control sensor.
2 Press and hold [MUTE] and [ ] on the remote
control for more than 4 sec.
All the indicators will blink for 10 sec when the code of
this system is changed.
The setting is maintained until it is changed again.
If the main unit does not operate after changing the code,
repeat steps 1 and 2.
To change the remote control code to code 1, repeat the
steps above, but replace
[] with [INPUT SELECTOR].
To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, It is possible to reduce the dialog enhancing
effect as follows:
While pressing and holding [SOUND] on the remote
control, press and hold [s VOL] on the main unit for more
than 4 sec.
All the indicators will blink once when the clear-mode dialog
effect is reduced.
Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
To reset the setting, return to the factory preset. (> 22)
To turn off the volume limitation
If a state of the lowered volume disturbs you every time
the main unit turns on, for example, it is possible to turn
off this function as follows:
While pressing and holding [MUTE] on the remote control,
press and hold [VOL i] on the main unit for more than
4sec.
All the indicators will blink once when the volume limitation
is turned off.
To reset the setting, return to the factory preset. (> 22)
Using the Dolby Virtual
Speaker effect
“STANDARD” indicator blinks:
3D surround effect and clear-mode
dialog effect is on.
“STEREO” indicator blinks:
3D surround effect and clear-mode
dialog effect is off.
Dimmer mode
Others
SC-HTB65_70PPC_RQT9763-1P.book Page 21 Thursday, February 7, 2013 4:24 PM