Filter
Top Products
Reference
27
VQT3R83
No sound (or image).
≥ Turn muting off. (> 22)
≥ Check the connections to the other devices.
(> 18 to 20)
≥ Make sure that the received audio signal is
compatible with this system. (> 6)
≥ Turn this system off and then on again.
≥ If this system is connected to the TV with only an
HDMI cable, make sure that the TV’s HDMI
terminal is labelled “HDMI (ARC)”. If not, connect
using the optical digital audio cable. (> 18, 19)
≥ If this system is connected to a Panasonic TV
and turned on using the button on the active
subwoofer or the remote control, sound might not
be output from this system. In this case, turn this
system on using the TV’s remote control. (> 24)
≥ If the connections are correct, there might be a
problem with the cables. Redo the connections
with different cables.
≥ Check the audio output settings on the connected
device.
≥ If the HDMI 2 indicator flashes and there is no
audio output, try the following.
1 Turn the connected device off and then on.
2 Turn off this system, remove the HDMI cable,
then reconnect the HDMI cable and turn this
system back on.
The dual audio cannot be changed from main to
secondary.
If the audio received from the connected device is
not “Dolby Dual Mono” or the output setting is not
“Bitstream”, the setting cannot be changed from
this system. Change the setting on the connected
device.
The volume is lowered when this system is
turned on.
If this system is turned off with the volume setting in
the greater half (above 50), this system will
automatically lower the volume to the middle (50)
when this system is turned on. (> 25)
The dialog is too persistent or the dialog does
not sound natural.
This system has a function to make the dialog
stand out when the volume is low. (> 25)
There is no audio.
This system turns off automatically.
(When this system detects a problem, a safety
measure is activated and this system automatically
switches to standby mode.)
≥ There is a problem with the amplifier.
≥ Is the volume extremely high?
If so, lower the volume.
≥ Is this system placed in an extremely hot place?
If so, move this system to a cooler place and wait
a few moments and then try to turn it on again.
If the problem persists, confirm the TV indicator and
HDMI 2 indicator blink, turn the system off, remove
the AC mains lead and consult your dealer. Please
be sure to remember the indicators that were
blinking and inform the dealer.
Sound
SC-HTB15EGEBGNGS_VQT3R83.book Page 27 Tuesday, June 28, 2011 2:34 PM