Filter
Top Products
RQT8607
7
Simple Setup
∫ Preventing the speakers from falling
≥You will need to obtain the appropriate screw eyes to match the
walls or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers.
∫ Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
≥
The wall or pillar on which the speakers are to be attached should be
capable of supporting over 10 k
g
per screw. Consult a qualified
building contractor when attaching the speakers to a wall. Improper
attachment may result in damage to the wall and speakers.
≥When mounting the front speakers or surround speakers
([Australia[and[N.Z.] front speakers only) to a wall, we recommend
using a string (not included) to prevent it from falling.
1 Attach the cover plate to the front speaker or surround speaker.
([Australia[and[N.Z.] front speaker only)
2 Drive a screw (not included) into the wall.
3 Fit the speaker securely onto the screw(s) with the hole(s).
Reattaching the speaker cable to the stand
1
Remove the eight screws from the stand, and remove the speaker net.
2 Position the cable.
3 Attach the speaker net with the screws.
∫ Fitting speaker stands (not included)
\Southeast\Asia,\Thailand,[the\Middle\East,\South\Africa,]
[Saudi\Arabia\and\Kuwait\
(For center speaker)
[Australia[and[N.Z.]
(For surround speakers and center speaker)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥The stands must be able to support over 10 kg.
≥
The stands must be stable even if the speakers are in a high position.
String (not included)
Thread from the wall to the
speaker and tie tightly.
Rear of the speaker
Wall
Approx.
150 mm
Screw eye
(not included)
Speaker installation options
Preparation for front and surround speakers
([Australia[and[N.Z.] front speakers only)
1 Remove the speaker cable from the stand.
2 Connect the cable (➜ page 6).
4 Cover plates
[Australia[and[N.Z.]
2 Cover plates
4 Screws
[Australia[and[N.Z.]
2 Screws
Release the cable
from the groove.
Screw
Tighten securely.
Cover plate
‰7.5 to 9.5 mm
5.0 to 7.0 mm
Wall or pillar
‰4.0 mm
106 mm
340 mm
Front and surround speaker
Front speaker [Australia[and[N.Z.]
200 mm
Center speaker
Surround speaker
[Australia[and[N.Z.]
In this position, the
speaker will likely
fall if moved to the
left or right.
Move the speaker
so that the screw
is in this position.
e.g.
Screw
Press the cable
into the groove.
Approx.15 cm
Cable
Speaker stand
(not included)
Plate thickness plus
7 mm to 10 mm
e.g. Center speaker
5 mm, pitch 0.8 mm
Metal screw holes
For attaching to
speaker stands
60 mm
Assembling the speakers