Filter
Top Products
17
RQTX1260
ENGLISH
The name of the connected device is shown as “¢”.
≥ Character that cannot be displayed will be replaced by “¢”.
≥ An unknown device name is detected and displayed as
“¢¢¢¢¢”.
Noise is heard or broken sound.
≥ The Bluetooth
®
communication distance has exceeded 10 m
(33 ft). Bring the device closer to the unit.
≥ There are obstructions between the device and the unit.
Remove or avoid the obstacles.
≥ Select “MODE 1” to improve connection quality (> 15).
≥ Interference from mobile phones.
The following messages or service numbers appear on the
unit’s display when something unusual is detected during
startup and use.
“--:--”
≥ You plugged the AC power supply cord in for the first time or
there was a power failure recently. Set the time (> 12).
“ADJUST CLOCK”
≥ Clock is not set. Adjust the clock accordingly.
“ADJUST TIMER”
≥ Play timer is not set. Adjust the play timer accordingly.
“PGM FULL”
≥ The number of programmed tracks is limited to 24. No further
tracks can be programmed.
“NO PLAY”
≥ A CD-ROM disc that is not in CD-DA or MP3 format is inserted.
It cannot be played.
≥ Check the content. Only MP3 format files can be played.
“ERROR”
≥ Incorrect operation is performed. Read the instructions and try
again.
“F61” or “F76”
≥ There is a power supply problem. Consult the dealer.
“AUTO OFF”
≥ The unit has been left unused for about 30 minutes and will
shut down in a minute. Press any button to cancel it.
“ILLEGAL OPEN”
≥ Sliding door is not in correct position. Turn the unit off and on
again.
“NODEVICE”
≥ The iPod/iPhone device is not inserted correctly. Read the
instructions and try again (> 12).
“REMOTE 1”
≥ The main unit is in “REMOTE 1” mode. Switch the remote
control to “REMOTE 1” mode (> 15).
“REMOTE 2”
≥ The main unit is in “REMOTE 2” mode. Switch the remote
control to “REMOTE 2” mode (> 15).
“DIMMER”
≥ Appears 10 seconds after the volume is turned to “0”.
[HC55] “F70”
≥ There is a Bluetooth
®
module problem. Disconnect the AC
power supply cord and consult your dealer.
“NO DISC”
≥ Insert the disc to be played (> 9).
“NOT SUPPORTED”
≥ You have inserted an iPod/iPhone that cannot be played
(> 12).
[HC55] “START ERROR”
≥ Check the iPhone/iPod touch.
Visit the below website for more information:
http://radio.vtuner.com/panasonic/en/
“UNLOCKED”
≥The iPod/iPhone docking switch lever is not locked in position.
Make sure that the iPod/iPhone docking switch lever is properly
pushed back into place (> 12).
[HC55] “CANNOT SET”
≥ Select an audio source other than “BLUETOOTH” or
“INTERNET RADIO”.
[HC55] Bluetooth
®
operations
Displayed messages
SC-HC55_35-RQTX1260.book 17 ページ ２０１１年４月４日 月曜日 午後４時５０分