Panasonic SC-AKX73 Stereo System User Manual


 
USB
You can connect and play MP3 tracks from your USB
device.
Do not use a USB extension cable. The system cannot
recognize USB device connected through a cable.
1
Connect the USB device to the USB port.
Hold the main unit when connecting or disconnecting
the USB device.
2
Press [USB] and then press [4/9] to start playback.
For other operation, refer to “Disc”.
Compatible USB devices which are defined as mass
storage class:
USB devices that support bulk-only transfer.
USB devices that support USB 2.0 full speed.
Note:
Files are defined as tracks and folders are defined as
albums.
Track must have the extension “.mp3” or “.MP3”.
This system can access up to:
– 800 albums (including albums without MP3 tracks)
– 8000 tracks
– 999 tracks in one album
CBI (Control/Bulk/Interrupt) is not supported.
NTFS file system is not supported (only FAT 12/16/32 file
system is supported).
Some files can fail to work because of the sector size.
Radio
Manual tuning
1
Press [RADIO, EXT-IN] (main unit: [RADIO]) to
select “FM” or “AM”.
2
Press [3] or [5] to select the frequency of the
required station.
To tune automatically, press and hold the button until
the frequency starts changing quickly.
” is shown when a stereo broadcast is being
received.
Improving the sound quality
When “FM” is selected
1
Press [RADIO MENU] to select “FM MODE”.
2
Press [Y, U] to select “MONO” and then press [OK].
To cancel, select “STEREO”.
“MONO” is also canceled when you change the
frequency.
When “AM” is selected
1
Press [RADIO MENU] to select “B.PROOF”.
2
Press [Y, U] to select “BP 1” or “BP 2” and then
press [OK].
Memory presetting
30 FM and 15 AM stations can be preset.
Automatic presetting
1
Press [OK] to select “LOWEST” or “CURRENT”
frequency.
2
Press [AUTO PRESET] to start presetting.
To cancel, press [8].
Manual presetting
1
Press [3] or [5] to tune in to the station.
2
Press [PROGRAM].
3
Press the numeric buttons to select a preset
number.
Do steps 1 through 3 again to preset more stations.
The new station replaces any station that occupies the
same preset number.
Selecting a preset station
Press the numeric buttons, [2] or [6] (main unit:
[2/3] or [5/6]) to select the preset station.
FM allocation setting
By main unit only
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
1
Press [RADIO] to select “FM” or “AM”.
2
Press and hold [RADIO].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
To go back to the initial setting, do the above steps again.
After you change the setting, preset frequencies are
erased.
Stop
playback
Press [8] during playback.
“RESUME” is shown.
Press [4/9] to continue playback from the
start of the track.
OR
Press [8] two times to stop the playback fully.
AKX73P.book Page 9 Tuesday, May 8, 2012 2:41 PM