Panasonic SC-HT940 Home Theater System User Manual


 
HT940]
Attach the speaker to the stand.
Place the polyfoam underneath the speaker for stability while
attaching the speaker to the stand.
(_ Feed the speaker cable {the shorter part) into the bottom
of the speaker and through the slot at the rear.
(_) While pulling the speaker cable up through the slot, slide
the speaker stand into the bottom of the speaker,
The speaker height
can be adjusted.
Min: 110 cm (43W')
Max: 135 cm (53s/3/')
(_) Insert the stand into the base while gently pulling on the
end of the cable.
Secure the stand to the base.
Tighten securely.
(_ Thread the cable through the middle hole of the slider and
fasten the slider with the two screws.
Cable
Screws
Tighten securely.
Attach the stand to the base.
(_) Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the leided portion through the hole, and then pull
the rest of the cable through the base.
Adjust the speaker height.
_) Loosen the screws until
the speaker can slide up
and down the stand.
(_) Raise the speaker to the
desired height, and then
re-tighten the screws,
Phillips-head
screwdriver
5
Connect the speaker cable.
Insert the wire fully. "_
+ :White _ |
Push! J
Press the speaker cable into the groove.
Push excess cable back through the
holder.
Secure the speaker cable to the base.
S
into the groove.
Preventing the speakers from falling
You will need to obtain the appropriate screw eyes to match the
walls or pillars to which they are going to be fastened,
Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result indamage to the wall or speakers,
e.g.rri'tt_I1_
Rear of the speaker
String (not included)
Thread from the wall to the speaker and tie tightly,
Approx.
150 mm
Screw eye Wall
(not included) (529/3/')