Panasonic SA-XR59 Stereo Receiver User Manual


 
ENGLISH
RQTV0247
17
Before playback
Speaker output and level
Adjust the level of the speakers so they are the same apparent level as the front speakers from the seating area.
Speaker level is adjusted during auto speaker setup. Do the following only if you find the level unsatisfactory.
To turn on SPEAKERS A.
Press
1
The unit does not output the test signal if only SPEAKERS B is
on.
If you have bi-wired your front speakers ( page
13), make sure you have selected “YES” for the
“LR BI-WIRE setting” ( page 27).
Press or
Press to output the test signal.
The signal is output from each speaker in order for
about two seconds each:
2
LCRRSSBRSBLLSSUBW
or LCRRSSB
1
LSSUBW
1
If you connect one surround back speaker only (the left
surround back speaker)
Set speakers volume to the level you would normally use.
Press
Volume range:
-- dB (minimum), -79 dB to 0 dB (maximum)
3
Press to select the speaker channel to adjust.
Press to adjust the level
to the same apparent level as the
front speakers.
Repeat steps 4 and 5 for each speaker channel.
Adjustment range:
-20 dB to +10 dB (Factory setting: 0 dB )
For the subwoofer (SUBW)
MIN (minimum) 1 to 29 MAX (maximum)
(Factory setting: 20 )
The test signal is output only from the speaker you are adjusting in
steps 4 and 5. Test signal for connected speakers resumes after 2
seconds.
4
5
Press to stop the test signal.
6
Speaker abbreviations
L: Front left C: Center
R: Front right RS: Surround right
LS: Surround left SBR: Surround back right
SBL: Surround back left SB: Surround back (If you connect
one surround back speaker)
SUBW: Subwoofer
SPEAKERS A are on SPEAKERS A and B are on
SPEAKERS
A
A
SPEAKERS
A B
SPEAKERS
SPEAKERS
A
SPEAKERS
B
A B
SPEAKERS
BI-WIRE
TEST
AUTO
VOLUME
LEVEL
TEST
AUTO
or
Automatic speaker detection
Automatic speaker detection is performed during auto speaker setup. Do the following only if you want to check speakers’ status, and
not other settings.
Turn on the unit.
Press
The standby indicator goes off when you turn on the unit.
Start automatic speaker detection.
Press at the same time.
1
2
SPEAKERS
A B
AUTO DETECTOR
These settings are saved even if you turn the unit off.
Refer to page 14 for further notes and page 16 for error message explanations. (“WARNING” may appears on the display during
the detection here.)
Make sure your speaker settings match your connections ( pages 13, and 14 to 16). There will be no output from a speaker if
it is set as NO or NONE ( page 27).
(Checks each speaker’s
connection status)
(Shows the number of detected
speakers, excluding the subwoofer)
(Shows connected speakers)
(Automatic speaker detection ends.
The previous display reappears)
SA-XR59 (RQTV0247-B).indb 17 6/5/2007 9:10:56 AM