Panasonic PT-DW730U Home Theater System User Manual


 
Technical Information
100 - ENGLISH
Appendix
REMOTE 2 IN terminal
It is possible to control the projector remotely (by external contact) from a control panel located away from
the projector where remote control signals cannot reach. Use the <REMOTE 2 IN> terminal on the side of the
projector to connect to the control panel.
Remote control External control
Remote control/External control
Standby ON
LAMP
RGB1 VIDEO
RGB2 S-VIDEO
DVI-D
Projector set up in a meeting room Control panel located in a different room
Pin assignments and signal names
D-Sub 9-pin (Outside view) Pin No. Signal name Open (H) Short (L)
(1) (5)
(6) (9)
(1) GND GND
(2) POWER OFF ON
(3) RGB1 Other RGB1
(4) RGB2 Other RGB2
(5) VIDEO Other VIDEO
(6) S-VIDEO Other S-VIDEO
(7) DVI-D Other DVI-D
(8) SHUTTER OFF ON
(9) RST/SET
Controlled by remote
control
Controlled by
external contact
Attention
z
When controlling, make sure to short-circuit pins (1) and (9).
z
When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control
cannot be used.
The
POWER ON <
> button, the STANDBY < > button, the <SHUTTER> button, and the corresponding
RS-232C commands and network functions cannot be used either.
z
When pins (1) and (9) are short-circuited, do not short-circuit any pins from (3) to (7) with pin (1). The following
buttons on the control panel and the remote control cannot be used.
The POWER ON < > button, the STANDBY < > button, the <RGB1> button, the <RGB2> button, the
<DVI-D> button, the <VIDEO> button, the <S-VIDEO> button, the <SHUTTER> button, and the corresponding
RS-232C commands and network functions cannot be used either.
Note
z
For pin (2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER]. (
page 64)