Filter
Top Products
RQTX0014
8
Simple Setup
AC cord connection/Preparing the remote control
Conserving power
The main unit consumes a small amount of power, even when it is in
standby mode (approx. 0.3 W). To save power when the unit is not to be
used for a long time, unplug it from the household AC outlet. You will
need to reset some memory items after plugging in the main unit.
[Note]
The included AC power supply cord is for use with the main unit only. Do
not use it with other equipment. Also, do not use cords for other
equipment with the main unit.
∫ Batteries
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥heat or expose to flame.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ page 11), avoiding
obstacles, at a maximum range of 7 m (23 feet) directly in front of
the unit.
step
3
AC cord connection
AC IN
To household AC outlet (AC 120 V, 60 Hz)
AC power supply cord (included)
Main unit
step
4
Preparing the remote control
R6/LR6, AA
Insert so the poles (i and j) match those in the remote control.
≥Do not use rechargeable type batteries.
Press in and lift up.
Replace the cover.
0014En_p03-13.fm Page 8 Friday, June 8, 2007 10:47 AM