Filter
Top Products
26
CQ-C9800/9700U
CQ-C9800/9700U
27
Note:
≥ New stations overwrite existing saved stations after this procedure.
Radio
Direct Memory (D·M)
This is a useful function that can call broadcast
stations directly during playback in other modes (CD,
CD Changer, etc.), even when the power is off.
Your favorite radio station can be memorized in
[D·M] (direct memory).
Default: FM 87.9 MHz
∫ Memorize
1 Select a band and frequency.
2 Press and hold [D·M] for more than
2 seconds.
≥ Frequency blinks once and is saved in the
memory.
Note:
≥ New stations overwrite existing saved stations
after this procedure above.
∫ Recalling the Direct Memory
Press [D·M].
Press [D·M] again to cancel.
[%] [$]
(TUNE)
[D·M] (Direct Memory)
E
N
G
L
I
S
H
7
E
N
G
L
I
S
H
8
[BAND]
(APM: Auto Preset Memory)
[SOURCE]
64
97
5
Car Audio
SOURCE
MUTE
POWER
RAND
VOL
312
DISPBAND
REP
6
5
SET
SEL
#
SCAN
MENU
NUMBER
8
0
[SOURCE]
[%] [$]
(Tuning)
[BAND]
(Auto Preset
Memory)
[1] to [6]
(Preset station)
Stereo indicator
Radio Mode
Press [SOURCE] to select the radio mode.
Radio mode display
1
Tuning
[$]: Higher frequency
[%]: Lower frequency
Press and hold [%] or [$] for more than
0.5 seconds, then release. Seeking will start.
3
FrequencyBand
Station Preset
Up to 6 stations can be stored in each of the FM1, FM2, FM3 and AM band selections.
Caution:
≥ To ensure safety, never attempt to preset
stations while you are driving.
Auto Preset Memory (APM)
Automatically save stations with good reception in
the preset memory.
1 Select a band (previous page).
2 Press and hold [BAND] (APM: Auto Preset
Memory) for more than 2 seconds.
≥ The 6 stations with good reception will be
automatically saved in the memory under
preset number 1 to 6.
≥ Once set, the preset stations are sequentially
scanned for 5 seconds each (scanning).
Manual Preset Memory
Manually save a station in the preset memory.
1 Select a band and frequency (previous page).
2 Press and hold ["] or [#] until the preset
number blinks.
3 Press ["] or [#] to select the preset number
(1 to 6).
4 Press and hold ["] or [#] for more than
2 seconds to memorize.
≥ The display blinks once, and a receiving station
is saved in the memory.
Preset Station Calling
1 Select a band (previous page).
2 Press ["] or [#].
Press [1] to [6].
Note:
≥ When pressing [MENU] (pressing and hold
[MENU] for more than 2 seconds on the remote
control unit) in radio mode, the following display
appears.
This is because radio mode does not have
any menu settings.
1 Select a band and frequency
(previous page).
2 Press and hold [1] to [6] for more than
2 seconds to memorize.
["] [#]
(Preset station)
Band
Press [BAND].
2
FM1 FM2 FM3 AM
Direct Memory mode
["] [#]
(Preset station)