Filter
Top Products
6
OPERATION
Your AMX 2 speakers have two operational modes: am-
plified (boost) or unamplified (direct). Use the boost mode
with low-powered sound boards and other audio sources
that have just enough power to drive a set of headphones
or earphones. Use the direct mode when you connect the
speakers to an audio source that has sufficient power to
drive the speakers without amplification.
If the sound level is too low when using the unamplified
mode with your audio source, use the the amplified
mode.
USING THE UNAMPLIFIED (DIRECT)
MODE
1. Turn your computer board or audio source’s volume
all the way down.
2. Move the slide switch on the back of the
R
speaker to
OFF
.
3. Turn on your audio source.
4. Adjust the volume on your audio source to a comfort-
able listening level.
OFF
40-1359.fm Page 6 Tuesday, August 10, 1999 3:03 PM