Filter
Top Products
SET
MODE
BAND
FUNCTION
TUNE TUNE
TUNE TUNE
Programming station presets
Selecting station presets
RDS
(RDS option only 7~8 page, only for model with RDS)
Receiving FM Stations with RDS
Tuning stations
RADIO
7
Select the tuner function.
pressed until tuning starts.
A station is being received.
FM stereo broadcasts with too much
noise can be switched to mono for less
noise.
Select the band.
To find weak stations too, press
repeatedly while tuning.
To find powerful stations quickly, tune
automatically keeping either button.
button on the
Remote Control
Mode button on the Unit is tape mode button (only Auto reverse option).
You can store up to 30 FM / 15 AM
stations.
Find a station as under "Tuning
stations".
Store.
The system assigns a station to a
number beginning with 1, one after
another.
Select lower or higher preset numbers.
On the machine select the tuner function and the band by pressing REPEAT/MODE/BAND button.
If you try to store a 31st FM / 16th AM station, the display will show "FULL".
To clear a preset station, select it, press / CLEAR, then / SET within 5 seconds.
You can use the MODE button of the remote control to switch back to stereo.
II
RDS (Radio Data System) is a broadcasting service which a
growing number of FM stations are now providing. It allows
the FM stations to send additional signals along with their
regular program signals. For example, the stations send their
station names and information about what type of program
they broadcast, such as sports or music, etc.
When tuned to an FM station which provides the RDS
service, the RDS indicator lights up, the station frequency
(and then the station name if sent) is displayed.
Not all FM stations provide RDS service, nor do all RDS
stations provide same services. If in doubt, check with local
radio stations for details on RDS services in your area.
This unit can use the following RDS service.
PS (Programme Service name)
RT (Radio Text)
PTY (Programme Type)
Identifies each station by
a name.
Allows the RDS station to send text
messages that appear on the display of
the unit.
Identifies the type of RDS
programme. This allows you to
locate a specific type name of
program being broadcast.
PRESET