Filter
Top Products
5
RADIO OPERATION
Operation
Press the power button to turn the unit on.
Press the Tuner button to change the radio mode. Then press the Tuner/Band button to select FM or AM.
You can hold the Tuning / Search Forward or REW button to select a desired station. If you hold the
Tuning/search Forward or REW button for more than half a second the unit will begin to automatically scan until
a strong signal is found or until the Tuning/Search Forward or REW button is pressed again.
Press AMS/RADOM on the remote control at the radio status, it will intros 10 second for each radio station of
memory, at this period ,you can select station when you press the button again.
TUNING TO A PRESET STATION
Select the desired program number by pressing the Memory UP/Repeat button.
Storing Stations
Tune either automatically or manually to the station to be stored. Press the
Memory Program button once; Memory will flash on the display. The display will disappear for 10 seconds;
during this time you must select the desired memory location by pressing The Memory Up/REPEAT button.
Press the Memory Program Button to store the station at that location.
The unit can store up to 20 FM Stations and 20 AM Stations.
ANTENNA
For FM reception there is a built-in one –meter FM Antenna wire at the rear of the unit.
Unravel the wire and move it around to obtain the best reception. For AM reception the signals are picked up
through the external frame antenna, you may have to move the frame antenna to obtain the best reception.
HANDLING COMPACT DISCS
To remove a disc from its storage case, press down on the center of the case and lift the disc out, holding it
carefully by the edges. Fingerprints and dust should be carefully wiped off the discs forward to the left of unit
with a soft cloth. Unlike conventional records, compact discs have no grooves to collect dust and microscopic
debris so gently wiping with a soft cloth should remove most particles.
Wipe in a straight line from the inside to the outside of the disc. Small dust particles and light stains will have
absolutely no effect on reproduction quality.
Never use chemicals such as record sprays antistatic sprays, benzene, or thinners to clean compact discs. These
chemicals can irreparably damage the discs surface. Discs should be returned to their cases after use. This avoids
serious scratches that could cause the Laser pickup to skip Do not expose discs to direct sunlight, high humidity