Sylvania SRCD909 Stereo System User Manual


 
4
REMOTE CONTROL AND BATTERY
INSTALLATION BATTERY
Insert 2pcs AAA size (Alkaline) batteries (not included) into the battery compartment of the remote control.
Be sure to observe the polarity markings, which are engraved inside the battery compartment, then close the
cover.
BATTERY REPLACEMENT
When the batteries become too weak. The operating distance of the remote controls greatly reduced and you will
need to replace the batteries.
Open the battery compartment cover, push out the battery (follow the exit direction in pushing out).
Push in the new battery in the opposite direction. Put the cover back and secure.
Note:
To maintain the accuracy and long life of the transmitter, do not press two or more buttons simultaneously.
If the remote control is not used for a long time, remove the batteries to prevent possible damage through leaking
batteries.
Do not mix different types of batteries, or old batteries with new ones.
USING THE REMOTE CONTROLLER CORRECTLY
Point the remote control at the Remote Sensor.
The functions of the buttons on the remote control are the same as the corresponding controls on the main unit.
When there is a strong ambient light source, the performance of the infrared Remote Sensor may be degraded,
causing unreliable operation.
The maximum effective distance for remote control operation is about 15feet.
CONNECTING TO POWER
Before switching on make sure that the voltage of voltage of your electricity supply is the same as that indicated
on the rating plate.
For your own safety read the following instructions carefully before attempting to connect this unit to the mains.