Filter
Top Products
2
2
Using Advanced Sound Options
S
ound Mode Adjustments
(
Remote Control Only)
Center Mode Setting
The center mode setting affects the center channel’s bass signals. It operates
only when you select Dolby Pro Logic Surround Sound. Slide
AUDIO/SURROUND
on the remote control to
SURROUND
. Each time you press
C. MODE
on the remote
control, the setting changes, and the receiver displays:
NORMAL
,
WIDE
,
PHANTOM
, or
3CHLOGIC
.
NORMAL
— Select this mode if you use a small center speaker. The front left
and right speakers play the center-channel bass sounds.
WIDE
— Select this mode if you use a medium or large center speaker. The
center speaker plays the center-channel bass sounds.
PHANTOM
— Select this mode if you have no center speaker. All center-chan-
nel sound comes from the front left and right speakers.
3CHLOGIC
— Select this mode if you do not have rear speakers. The rear
channel’s sound is sent to the front left and right speakers.
Test Tone
The test tone feature provides a test tone that lets you balance the signal levels
between all your speakers. See “Center Level” and “Rear Level.”
To activate the test tone, select one of the surround sound modes (except
PHANTOM) and set
AUDIO/SURROUND
on the remote to
AUDIO
. Then press
TEST
TONE
. The receiver sounds a 2-second tone from the front left, center, front right,
and rear speakers, in sequence.
Notes:
• The center test tone does not sound if you select PHANTOM surround
sound mode.
• In the Dolby 3CH Logic Sound mode, the receiver sounds a 2-second
tone from the left, center, and right speakers, in sequence.
Press
TEST TONE
again to turn off this feature.
Center Level
Slide
AUDIO/SURROUND
to
AUDIO
. Then press
– CENTER
LEVEL
+
to adjust the cen-
ter speaker sound level.
Rear Level
Slide
AUDIO
/
SURROUND
to
SURROUND
. Then press
– REAR +
to adjust the rear
speakers’ sound level.
Both
CENTER
and
REAR LEVEL
work only for the sound system that supports the
center or rear speakers. For example,
REAR LEVEL
does not work for Dolby 3CH
Logic.
Note:
If you do not use a center speaker,
the monaural signals are reproduced
only if you select PHANTOM.
Note:
Use the
VOLUME
control to adjust
the overall sound level.