Filter
Top Products
11
2. Connect the external source to the
AUX jack using a patch cord with a
1
/
8
-inch plug.
3. Start the external audio source
and set its volume control to a nor-
mal listening level.
4. Press
RECORD to begin record-
ing. Both
PLAY and RECORD lock
down.
Note:
To temporarily stop record-
ing, press
PAUSE. To resume
recording, press
PAUS E again.
5. Press
STOP/EJECT to stop record-
ing. Then stop the audio source.
Note:
During recording, the speaker is
muted. If you want to monitor the re-
cording, use the supplied earphone.
USING THE TAPE
COUNTER
You can use the tape counter to help
you find specific locations on the tape.
At the beginning of a tape, press
TAPE
COUNTER
to reset the tape counter to
000. Then note the counter’s reading
at the beginning of each selection.
To return to a selection, fast-forward or
rewind the tape until the counter shows
the noted reading.
TAPE TIPS
Recommended Tapes
Tape quality greatly affects the quality
of the recording. We recommend ex-
tended-range or low noise Type 1 reg-
ular length (60- or 90-minute) normal-
bias cassette tapes. We do not recom-
mend long-play cassette tapes such as
C-120s because they are thin and can
easily tangle.
Erasing a Cassette Tape
To record over a cassette tape, simply
record as usual. The cassette deck
records over the previous recording.
DC IN 6V
AUX
EAR
REM
MIC
TONE VOLUME
External
source
000
TAPE COUNTER RECORD
14-1116.fm Page 11 Friday, January 8, 1999 10:30 AM