Filter
Top Products
6
TESTING THE
CONNECTIONS
Follow these steps to check your au-
tosound system before adjusting and
mounting the crossover.
1. Turn on your autosound system
and adjust the volume to a com-
fortable level. The POWER indi-
cator lights.
2. Play a cassette tape or CD that
has a wide dynamic range, or
tune to a strong FM station.
3. If the sound from any speaker is
distorted or has static (or if there
is no sound from a speaker), turn
off the power immediately, then
check the wiring connections.
If the system sounds with no dis-
tortion or static, proceed to “Ad-
justing the Controls.”
ADJUSTING THE
CONTROLS
Setting the Low Pass
Crossover Point
The
LOW PASS
selector lets you set
one of three crossover points. All sig-
nals at or below the selected frequen-
cy “cross over” to your subwoofer
speakers.
Set the selector to
180 Hz
to increase
the range of low-frequency sounds.
Set the selector to
90 Hz
or
50 Hz
to
decrease the range of low-frequency
sounds.
12-2012.fm Page 6 Tuesday, July 13, 1999 2:50 PM