Filter
Top Products
5
Connections
Connecting to Your
Receiver/Amplifier
1. Using one of the supplied audio cables, connect the cassette
deck’s
L
and
R
LINE OUTPUT
jacks to the receiver/amplifier’s left and
right tape input jacks.
2. Using the other audio cable, connect the cassette deck’s
LINE INPUT
jacks to the receiver/amplifier’s tape output jacks.
Note: If you are not sure which receiver/amplifier jacks to use, refer to
your receiver/amplifier’s owner’s manual.
Connecting the Remote
Control Cable
If you have an Optimus receiver/amplifier that has a remote control
jack (labeled
CONTROL IN/OUT
), you can use the receiver/amplifier’s remote
control to operate the cassette deck.
Connect the receiver/amplifier’s
CONTROL OUT
jack to the cassette deck’s
CONTROL IN
jack using the supplied remote control cable.
If you have another Optimus audio component that has a remote con-
trol jack, connect the cassette deck’s
CONTROL OUT
jack to the compo-
nent’s
CONTROL IN
jack. This relays the remote control signal from the
receiver/amplifier to the other component.
Note: You must also connect audio cables to your receiver for the
receiver’s remote control to operate your cassette deck.
Connecting the CD-Deck
Synchro Control Cable
If you have an Optimus CD player that has a
CD-DECK SYNCHRO
control
jack, connect the jack to your cassette deck’s
CD-DECK SYNCHRO
control
jack using the supplied CD-deck synchro control cable. This connection
lets you easily make CD-to-cassette deck recordings. See “CD-Deck
Synchro Recording” on Page 13.
Connecting Power
Carefully check all connections. Then plug the AC power cord into a
standard AC outlet. The power cord’s plug is polarized and fits only one
way. The cassette deck automatically turns on.
Warning: To prevent electric shock, do not plug the power cord into an
extension cord or other receptacle unless you can fully and easily insert
the plug’s blades.