Filter
Top Products
48
Using the tone control:
To make bass and treble adjustment work for multichannel sources,
you must first set the tone control to “On.”
To turn on the tone control:
1. Press the SURROUND button (or SURR button on the
remote controller).
“Tone On” appears on the display and the tone control is turned
on.
2. Press the AUDIO ADJUST button and then the and
cursor buttons to select Bass (or Treble).
3. Press the and cursor buttons to set the desired
level.
To turn off the tone control:
Press the DIRECT button.
“Tone Off” appears on the display and the tone control is turned
off.
Notes:
• When you play back multichannel sources, you can select the
Pure Audio mode by pressing the PURE AUDIO button.
To exit the Pure Audio mode, press the DIRECT or SURROUND
button (TX-SR700/700E only).
• If you change the speaker levels in step 4 above, these new levels
for multichannel sources will have no effect on the settings at
“Level Calibration.”
Selecting an Audio Component
TX-SR700/700E/600/600E Remote controller
TX-SR700/700E/600/600E Remote controller
• Be aware that the main volume display on the front panel will
differ if the speaker volume of even one speaker is changed from
0 decibels. In other words, if all the speaker levels are set to 0
decibels and you increase the main volume, the display will rise
to “98,” “99,” and then “MAX.” If you now change the level of
one speaker to +5 decibels and you increase the main volume,
the display will rise to “93,” “94,” and then “MAX.”
Switching the display
While listening to or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the DISPLAY button on the TX-SR700/700E/600/600E or
the remote controller.
When an input source other than FM or AM is selected:
* If the input signal does not have a program format, then this will
be skipped.
When FM or AM is selected as the input source:
Temporarily turning off the sound
To turn off the sound momentarily, press the
MUTING button on the remote controller.
The MUTING indicator will flash and the
sound from the speakers or headphones will
be switched off by the receiver’s audio
muting circuit. Press the MUTING button
again to turn the sound back on.
Input + volume
Program format*
Input +
Listening mode
or Multich
FM/AM frequency +
Preset no.
FM/AM +
Listening mode
ch
Remote controller
Flashes
Remote controllerTX-SR700/700E/600/600E
TX-SR700/700E/600/600E Remote controller
Remote controllerTX-SR700/700E/600/600E