Onkyo TX-SA806 Stereo Receiver User Manual


 
40
Turning On the AV Receiver/AV Amplifier
For non-North American models: To completely shut down the AV receiver/AV amplifier, set the [POWER] switch
to the OFF position ().
ON/STANDBY ON/STANDBY
POWER
ON/STANDBY
RECEIVER
STANDBY indicator
STANDBY indicator
North American models Other models
Turning On and Standby
1
Set the [POWER] switch to the ON position ( ).
(Skip this step if you have the North American model.)
The AV receiver/AV amplifier enters Standby mode, and the STANDBY indicator
comes on.
2
Press the [ON/STANDBY] button.
Alternatively, press the remote controller’s [RECEIVER] button, followed
by the [ON/STANDBY] button.
The AV receiver/AV amplifier comes on, the display lights up, and the STANDBY
indicator goes off.
To turn the AV receiver/AV amplifier off, press the [ON/STANDBY] button, or press
the remote controller’s [ON/STANDBY] button. The AV receiver/AV amplifier will
enter Standby mode. To prevent any loud surprises when you turn on the AV
receiver/AV amplifier, always turn down the volume before you turn it off.
or
R
emo
t
e
controller
AV
rece
i
ver
/
AV amplifier
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver/AV amplifier before you
use it for the very first time. These settings only need to be made once.
Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup (Audyssey MultEQ
®
)” on page 51.
Did you connect your TV to the HDMI OUT or COMPONENT
VIDEO MONITOR OUT?
If you did, see “Monitor Setup” on page 41.
Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 44, “Component Video
Setup” on page 45, or “Digital Input Setup” on page 46 respectively.
Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see “Changing the Input Display” on page 50.
HDMI
OUT IN
TAPE
CD recorder, MD recorder,
RI Dock
TX-SR806_En.book Page 40 Monday, August 4, 2008 10:25 AM