Filter
Top Products
Advanced Operations
En-80
12V Trigger Out
When Zone 2 is turned on, the output from the
ZONE 2 12V TRIGGER OUT jack goes high (+12 V
and max. 150 mA for Zone 2). Connecting this jack to
a 12-volt trigger input on a component in Zone 2 will
make that component turn on or off as the AV
receiver turns on or off the Zone 2.
■ Operating on the AV receiver
Tip
• The Whole House Mode function shares the input source of
main room with Multi Zone (➔ page 53).
■ Operating on the remote controller
To control Zone 2/3, you must press ZONE on the
remote controller first.
ZONE turns red when Zone 2 is on, and green when
Zone 3 is on.
Adjusting the Volume for Zone 2
■ Operating on the remote controller
■ Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver
or integrated amplifier in Zone 2, use its volume
control to adjust the volume.
Controlling Multi Zone Components
ZONE 2 ZONE 3
MASTER VOLUME
ON/STANDBY
Input selector buttons
1
To turn on Zone 2/3 and select an input source,
press ZONE 2 or ZONE 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on
the AV receiver’s display.
Tip
• The Zone 2 trigger output goes high (+12 V).
To select AM or FM, press ZONE 2 or ZONE 3
and the TUNER input selector repeatedly.
To select the same source as the main room’s,
press ZONE 2 or ZONE 3 twice. “Zone 2
Selector: Source” or “Zone 3 Selector: Source”
appears on the AV receiver’s display.
2
To turn off Zone 2/3, press ZONE 2 or ZONE 3
followed by ON/STANDBY within 8 seconds.
The zone is turned off.
Tip
• The Zone 2 trigger output goes low (0 volts).
RECEIVER
MUTING
VOL /
ZONE
Input selector buttons
1
Press ZONE repeatedly, then point the remote
controller at the AV receiver and press
RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on
the AV receiver’s display.
Tip
• The Zone 2 trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press
ZONE repeatedly, followed by an INPUT
SELECTOR button.
To select AM or FM, press ZONE and the TUNER
input selector repeatedly.
3
To turn off Zone 2/3, press ZONE repeatedly,
followed by RECEIVER.
The zone is turned off.
Tip
• The Zone 2 trigger output goes low (0 volts).
1
Press ZONE repeatedly to select Zone 2.
2
Use VOL / .
1
Press ZONE 2 (the Z2 indicator on the AV
receiver’s display flashes).
2
Use MASTER VOLUME control within 8
seconds.